Husqvarna 917.250093 Owner's Manual page 15

SERVICE AND ADJUSTMENTS
CHECK TINE OPERATION
• See "TINE OPERATION CHECK" in this section of
manual.
REPLACE BELT GUARD
FORWARD MOTION (INSIDE) V-BELT
REVERSE
BELT GUIDE
IDLER
PULLEY
ENGINE
PULLEY
BELT GUIDE
FORWARD IDLER PULLEY
REVERSE (OUTSIDE) V-BELT
REVERSE
IDLER
PULLEY
ENGINE
PULLEY
FORWARD
IDLER PULLEY
FRONT VIEW REFERENCE
REVERSE IDLER PULLEY
REVERSE IDLER ARM
REVERSE IDLER PULLEY
IDLER ARM PIN
FORWARD MOTION
(INSIDE) V-BELT
ENGINE PULLEY
BELT GUIDE
FOR WARD IDLER PUL LEY
TRANS MIS SION
PULLEY
ARM PIN
ENGINE
PULLEY
Fig. 21
ENGINE
Maintenance, repair, or replacement of the emission control
devices and systems, which are being done at the cus tom-
ers expense, may be performed by any non-road engine
repair establishment or individual. Warranty repairs must
be performed by an authorized engine manufacturer's
service outlet.
TO ADJUST CARBURETOR
The carburetor has been preset at the factory and ad just-
ment should not be necessary.
IMPORTANT: NEVER TAMPER WITH THE ENGINE GOVERNOR,
WHICH IS FACTORY SET FOR PROPER ENGINE SPEED.
OVERSPEEDING THE ENGINE ABOVE THE FACTORY HIGH
SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE
ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING,
CONTACT YOUR NEAREST AUTHORIZED SERVICE CENTER/
DEPARTMENT, WHICH HAS THE PROPER EQUIPMENT AND
EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS.
IDLER
Fig. 22
15
REVERSE (OUTSIDE)
V-BELT
BELT GUARD BOLT
TRANS MIS SION
PUL LEY