Can-Am Spyder RT Operator's Manual page 60

BASIC PROCEDURES
NOTICE
Do not exceed the maxi-
mum allowed pressure. This might
damage the air suspension.
MINIMUM PRESSURE 70 kPa / 10 Psi
DO NOT EXCEED RECOMMENDED PRESSURE BY
(PASSENGER + CARGO) Kg / Lb
LOAD
0 45/100
Kg/Lb kPa/Psi kPa/Psi kPa/Psi kPa/Psi
70/150
310/45 380/55
90/200
345/50 415/60
115/250 450/65
704904300
NOTE: When adjusting the pressure,
do not put your weight on the vehicle
and do not load cargo in the storage
compartment.
The air spring is connected directly to
an air hose with a schrader valve lo-
cated under the seat.
rmo2010-001-056_a
1. Schrader valve
To change the air pressure, proceed
the same way as for setting the pres-
sure in a tire.
When finished, ensure to reinstall cap
on the valve.
ACS Rear Suspension Adjustment
(with Remote Adjustment)
Adjustment Guidelines
The rear suspension is calibrated for a
general riding and will adjust automati-
cally, using an integrated compressor,
while riding to maintain this preset
______________
58
70 kPa / 10 Psi
704904300
70/150 90/200 115/250
kPa/Psi
450/65 480/70 515/75
480/70 515/75 550/80
515/75 550/80 585/85
when the road conditions change or if
the vehicle load changes (adding a pas-
senger, riding with more cargo, etc.).
NOTE: It is normal to hear pressure re-
lease or the air compressor operating
while engine is running. It indicates
the suspension is self-adjusting.
If the driver desires a softer or a stiffer
adjustment than the factory setting,
he can adjust the rear suspension by
pressing the ACS switch in the switch
cluster. By changing the ACS setting,
air pressure in the air spring will change
to provide a customized suspension
adjustment.
The following suspension settings are
available.
ACS SUSPENSION SETTINGS
BAR GRAPH
INDICATION IN
MULTIFUNCTION
GAUGE
1 (top)
2
3
4
5 (bottom)
Adjusting Suspension
(while Riding)
1. Press the ACS switch once (either
UP or DOWN). The digital display
will enter the suspension adjust-
ment mode.
RIDING
POSITION
Lowest
Low
Middle
High
Highest