Yamaha YZF-R1 Owner's Manual page 23

CAUTION:
Do not operate the engine in the ta-
chometer red zone.
Red zone: 13750 r/min and above
Clock mode
1. Clock
2. Speedometer
Turn the key to "ON".
To set the clock
1. Push the "SELECT" button and
"RESET" button together for at
least two seconds.
2. When the hour digits start flashing,
push the "RESET" button to set the
hours.
INSTRUMENT AND CONTROL FUNCTIONS
ECA10031 3. Push the "SELECT" button, and
the minute digits will start flashing.
4. Push the "RESET" button to set
the minutes.
5. Push the "SELECT" button and
then release it to start the clock.
Odometer, tripmeter, and stopwatch
modes
1. Coolant temperature display/air intake
temperature display
2. Odometer/tripmeters/fuel reserve
tripmeter/stopwatch
3. Shift timing indicator light
Push the "SELECT" button to switch
the display between the odometer
mode "ODO", the tripmeter modes
"TRIP A" and "TRIP B" and the stop-
watch mode in the following order:
TRIP A → TRIP B → ODO → Stop-
watch → TRIP A
If the fuel level warning light comes on
(see page 3-3), the odometer display
will automatically change to the fuel re-
serve tripmeter mode "F-TRIP" and
start counting the distance traveled
from that point. In that case, push the
"SELECT" button to switch the display
between the various tripmeter, odome-
ter, and stopwatch modes in the follow-
ing order:
F-TRIP → Stopwatch → TRIP A →
TRIP B → ODO → F-TRIP
To reset a tripmeter, select it by push-
ing the "SELECT" button, and then
push the "RESET" button for at least
one second. If you do not reset the fuel
reserve tripmeter manually, it will reset
itself automatically and the display will
return to the prior mode after refueling
and traveling 5 km (3 mi).
Stopwatch mode
Standard measurement
1. Push the "RESET" button to start
3-9
the stopwatch.
3