Sealey VS8801 Manual page 46

2) After the erase procedure is performed, status of most monitors
will be changed. Leave the code reader connected to the vehicle,
and select Ready Test from Main Screen.
3) Keep on driving the car till the code reader notifies you safely with
color LEDs and audible tone that the drive cycle has been
completed and the vehicle is ready, eliminating drive cycle
guesswork and confirming readiness status.
4) If the GREEN LED lights and two long beeps are heard, your
vehicle is ready and the repair work is confirmed.
5) If the RED LED lights, your vehicle is not ready and the repair
work is unsuccessful.
As pre-check diagnostic tool
Prior to having a vehicle inspected for compliance to a state
emissions test, you could use this function to check the readiness
status first by yourself.
1) While the code reader connected to the vehicle, select Ready Test
from Main Screen. Drive the car till the code reader notifies you
safely with color LEDs and audible tone if your vehicle is ready
to conduct state emission test.
2) If the GREEN LED lights and two long beeps are heard, your
vehicle is ready and there is a good possibility that it can be
certified.
3) If the RED LED lights, your vehicle is not ready and must be
repaired before an emissions test can be performed.
IMPORTANT: If you are driving the vehicle to perform a drive
cycle ALONE, please set the Status Beep On (see 3.7 System Setup).
By listening to the beep, you will learn when the monitors have run
and completed the diagnostic testing. NEVER try to drive and
operate the code reader at the same time!
43