HAMPTON BAY Carrison 499 461 Owner's Manual page 8

Ceiling
joist
Hanger
bracket
Hook
#14 Wood
screws
Figure 6
Hanger
bracket
Figure 7
5.
Make the Electrical Connections
WARNING: To avoid possible electrical shock,
Outlet box
be sure electricity is turned off at the main fuse
box before wiring.
AC Wires
NOTE: This remote control unit is equipped
with 16 code combinations to prevent possible
interference from or to other remote units. The
frequency switches on your receiver and
Lock
washers
transmitter have been preset at the factory.
Metal
washers Please recheck to make sure the switches on the
Star
transmitter and the receiver are set to the same
washers
position,
operate the fan as long as the transmitter and
receiver are set to the same position.(Fig. 8)
Step 1. (Figure 9) Insert the receiver into the
mounting bracket with the flat side of the
receiver facing the ceiling.
Step 2. (Fig. 10) Motor to Receiver Electrical
Connections: Connect the black wire from
Safety cable
the fan to black wire marked "TO MOTOR L".
Connect the white wire from the fan to the
white wire marked "TO MOTOR N" from the
receiver. Connect the blue wire from the fan to
the blue wire marked "For Light" from the
receiver. Secure the wire connections with the
plastic wire nuts provided.
any combination of settings will
Step 3. (Fig. 10) Receiver to House Supply
Wires Electrical Connections: Connect the
black (hot) wire from the ceiling to the black
wire marked "AC in L" from the receiver.
Connect the white(neutral) wire from the
ceiling to the white wire marked "AC in N"
f r o m t h e R e c e i v e r. S e c u r e t h e w i r e
connections with the plastic wire nuts
provided.
Step 4. (Fig. 10) If your outlet box has a
ground wire (green or bare copper) connect it
to the fan ground wires; otherwise connect the
hanging bracket ground wire to the mounting
bracket. Secure the wire connection with a
plastic nut provided. After connecting the
wires spread them apart so that the green
and white wires are on one side of the outlet
box and black and blue wires are on the other
side. Carefully tuck the wire connections up
into the outlet box.
Note: Fan must be installed at a maximum
distance of 20 feet from the transmitting unit
for proper signal transmission between the
transmitting unit and the fan's receiving unit.