Table of Contents
Advertisement
INSTALLATION PARTS
1.
Bracket (L)
x l
6. Tapping SCREW
X 4
11.
Power Cable
Yellow
5mxl
WIRING
Be sure to press this button when all wiring is completed or when
l
l
Press the reset button when a malfunction occurs during CD play ("E01
The magazine comes out.
* If the magazine dose not come out or "EOI" often appear in the display, please contact the place of purchase.
2. Bracket (R)
3. Bracket (B)
X l
8.
7.
seal
Nut
M 6
x 4
x l
2. +12V Power wire (YELLOW)
5. Changer selector switch
Do not use this switch if only 1 CD changer is being used.
It is used only when 2 CD changers (FXD-C222) are attached.
On how to use it, refer to the operation manual of the divider unit
4. Hexagonal bolt
9. Double sided tape
1. DIN cable (8-pin)
Connect this cable to the FXR-61TB, LB, GB/FXR-71TB, LB/FM
Modulator/Ground
isolator
Connect this wire to a terminal which is always energized.
hen fuse replacement is necessary, use only a 5 amp fuse.
3. Ground wire (BLACK)
Attach this wire to the chassis of the car. Be sure that the surface
is free of paint, and is not rusty. If a proper ground connection is
not made, the CD changer may not operate correctly and stray
noise may be picked up by the unit.
Car battery is replaced.
5. Hexagonal bolt
with washer
10. RIN 8pin cable
5mxl
or
Divider
unit.
Advertisement
Table of Contents
