Before Starting; Installing The Discharge Chute; Unfolding The Handle - Toro Snow Commander 38600 Operator's Manual

Setup

Unfolding the Handle

1. Cut the plastic tie that secures the control cable
to the handle.
2. Loosen the
knobs and pull
out the handle
bolts.
3. Rotate the
upper handle to
the operating
position.
4. Install the
handle bolts, set
the cable guide in
position, and
tighten the knobs
until they are
snug.
5. Adjust the rotor control cable and the traction
drive cable. Refer to Adjusting the Rotor Control
Cable on page 8 and to Adjusting the Traction Drive
Cable on page 9.
5
Installing the Discharge
Chute
Install the discharge chute as shown.
m-6103a
m-5046
m-6257a

Before Starting

Gasoline is extremely flammable and explosive. A
fire or explosion from gasoline can burn you and
others.
To prevent a static charge from igniting the
gasoline, place the container and/or
snowthrower on the ground before filling, not
in a vehicle or on an object.
Fill the tank outdoors when the engine is
cold. Wipe up spills.
Do not handle gasoline when smoking or
around an open flame or sparks.
Store gasoline in an approved fuel container,
out of the reach of children.
3329-430
m-5547/m-6187
Danger