Toro 73470 Setup Instructions
  1. Manuals
  2. Brands
  3. Toro Manuals
  4. Lawn Mower
  5. 73470
  6. Setup instructions
Toro 73470 Setup Instructions

Toro 73470 Setup Instructions

Hide thumbs Also See for 73470:
Table of Contents

Advertisement

Quick Links

Download this manual

Loose Parts

Note:
Use the chart below to identify parts for assembly.
DESCRIPTION
Seat Assembly
Shoulder Bolt – 5/16"
Locknut – 5/16"
Steering Wheel
Boot Washer
Nut
Lock Washer
Trim Cover
Bolt – 1/4"-20 x .75" Long
Hex Nut – 1/4"-20
Hitch Pin
Hairpin Cotter
Flat Washer – .50" I.D.
Key
Operator's Manual
Riding Mower Safety Video
Triple Crown Club Card
Printed in USA
518xi, 520xi & 522xi GARDEN TRACTOR
MODEL NO. 73470–8900001 & UP
MODEL NO. 73540–8900001 & UP
MODEL NO. 73560–8900001 & UP
QTY.
1
2
2
1
1
1
1
1
2
2
1
1
2
1
1
1
1
The Toro Company – 1997
All Rights Reserved
FORM NO. 3319–226
INSTRUCTIONS
USE
Installing the seat
Installing the steering wheel
Attaching the battery cables
Installing the drawbar hitch pin
Use in ignition switch
Read before operating the tractor
Attach to the tractor
Mail
SET UP

Advertisement

Table of Contents
loading

Related Manuals for Toro 73470

Summary of Contents for Toro 73470

  • Page 1: Loose Parts

    FORM NO. 3319–226 518xi, 520xi & 522xi GARDEN TRACTOR MODEL NO. 73470–8900001 & UP SET UP MODEL NO. 73540–8900001 & UP INSTRUCTIONS MODEL NO. 73560–8900001 & UP Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY.

  • Page 2: Installing The Seat

    Set-Up Instructions Installing the Seat Mount the seat to the seat base using two 5/16” shoulder bolts and lock nuts (Fig. 1). Insert the seat switch wire through the center opening in the seat base (Fig 1). Push the seat switch wire connector into the wire harness connector.

  • Page 3: Installing The Steering Wheel

    Set-Up Instructions Installing the Steering Wheel Install the boot washer onto the steering shaft (Fig. 2). Remove the plastic trim cover from the steering wheel (Fig. 2) Install the steering wheel onto the shaft, carefully aligning the splines (Fig. 2). Note: On manual steering models, be sure to align steering wheel in the straight...

  • Page 4: Checking Front Wheel Toe-In

    Set-Up Instructions Checking Front Wheel Toe–In Checking Tire Pressure With the tractor on a level surface, check to Check front and rear tire pressure. The correct front make sure the front wheel toe-in is between 1/8” and rear tire pressure is 12 psi (82.7 kPa). and 1/4”.

  • Page 5: Activating The Battery

    Set-Up Instructions Activating the Battery POTENTIAL HAZARD Battery electrolyte contains sulfuric acid which is a deadly poison and it causes severe burns. WHAT CAN HAPPEN If you carelessly drink electrolyte you could die or if it gets onto your skin you will be 1262 burned.

  • Page 6: Installing The Drawbar Hitch Pin

    Set-Up Instructions Installing the Drawbar Hitch When the battery is fully charged, unplug the charger from electrical outlet, then disconnect the charger leads from the battery posts (Fig. 4). Insert the drawbar hitch pin into the drawbar hitch and secure it with a .50” I.D. flat washer and hairpin cotter (Fig.

  • Page 7: Checking The Wiring And Fasteners

    Set-Up Instructions Checking the Wiring and Burnishing the Clutch Fasteners The following break–in procedure must be performed as part of predelivery service or when a new clutch is Inspect the tractor for any loose electrical installed. connections and secure them as required. Check the wire routing to make sure moving parts do Note: There must be a PTO driven...

  • Page 8: Test Driving The Tractor

    Set-Up Instructions Test Driving the Tractor As applicable, check and test the operation of the following: Check the oil level in the crankcase (refer to Engine, choke and throttle controls Engine Oil in your tractor Operator’s Manual for oil type, viscosity and crankcase capacity). Gauges Note: When checking the oil level, slide the...

Table of Contents