Inlet Hose Connection - NEC NWTL656 User Manual

Be careful not to confuse the hot water inlet and the cold-water inlet.
In using only one water tap or in case of one water inlet valve attached, connect the inlet hose
to the cold-water inlet valve.
For Ordinary Tap
1. Pull down the collar of the
inlet hose to separate it
from the water tap adapter.
4. Remove the tape, and
screw connector B into
connector A tightly.
Connector A
Connector B
For Screw-Shaped Tap
1. Connect the inlet hose to
the water tap by screwing
the connector tightly.
Connector
Hose Connector

INLET HOSE CONNECTION

2. Loosen the four screws
properly in fitting onto the
water tap
5. Connect the inlet hose to
the water tap adapter by
pulling down the collar of the
hose end.
2. Connect the connector
inlet supplied necessary.
Connector
Inlet
Connector
Hose Connector
3. Fit the water tap adapter
into the water tap and tighten
the four screws evenly while
pushing up the adapter so
that the rubber packing can
stick to the tap tightly.
6. Connect the inlet hose
adapter of the hose to the
water inlet of the washer by
turning it clockwise to tighten.
• Please check the rubber
packing inside the inlet
hose adaptor of the hose.
3. Insert the inlet hose
adapter into the water inlet of
the washer and turn it to
tighten.
• Check the packing in the inlet
Tape