Related Manuals for Toro 21012
Summary of Contents for Toro 21012
- Page 1 ® Recycler 43 cm Model 21012, 21014 43 cm Serial-No: 210000101 & up Operator's Manual Operator's Manual Operator's Manual Operator's Manual Operator's Manual © 2004 by The Toro Company Translation of the Original (EN)
-
Page 2: Table Of Contents
General Maintenance and Upkeep Safety Spare Parts and Troubleshooting Assembly and Start-up Hints on Tending the Lawn Operation © 2004 by The Toro Company... -
Page 3: General
190 cc nance. The TORO lawn mower has been designed for the private use in the garden. Lawn mowers for the private garden are units which motor speed: 3000 min... -
Page 4: Ec Declaration Of Conformity
Bloomington, MN 55420-1196, USA Declare that the machine Lawnmower, walk behind with combustion engine (EN836) Type: TORO 21020 / 21022, Cuttingwidth: 43cm Conforms to the specifications of the following EC directives: 98/37/EG, 89/336/EWG, 84/538/EWG Where appropriate applied standards: EN 836, EN ISO 14982... -
Page 5: Safety
Safe operation • after the lawn mower has hit against a foreign matter. Check regarded as inexpedient. The Toro Company is not liable for 1. Do not let the motor run indoors. your lawn mower for damage and make the necessary damages resulting from this. - Page 6 Always keep connecting cable away from blade. If the blade catches or cuts the cord, immediately unplug the cable from the outlet. clutch engaged wheel high motor speed low motor speed (idle) wheel drive © 2004 by The Toro Company...
-
Page 7: Assembly And Start-Up
11 Oil filling pipe and oil measuring stick refer to chapter start-up 12 Air filter Cleaning refer to chapter maintenance and upkeep 13 Spark plug connector plug on spark plug before start-up 14 Wash-out Port © 2004 by The Toro Company... - Page 8 (fig. 4). 5. Attach starter rope to the eye bolt at the handle (fig. 6. Attach cable with velcro fasteners or cable binders to the handle (fig. 6). © 2004 by The Toro Company...
- Page 9 1. First push the mower onto the lawn - the scale must be parallel to the ground. setting height-of-cut B - F 2. Now you can read the length of the uncut grass on the scale and choose the recommended adjustment. © 2004 by The Toro Company...
- Page 10 After sufficient fuel has been filled in, close the tank cover with manual force and wipe off spilled fuel, if any. Do not fill up fuel up to the filling pipe, but leave an "expansion space" of approx. 1 cm. © 2004 by The Toro Company...
- Page 11 © 2004 by The Toro Company...
- Page 12 • With grass heights greater than or equal to 15 cm, the lawn should be mowed in two steps. • In hot summers, adjust the cutting height on C, D, E or F. Do not cut off more than a third of the grass leaf. © 2004 by The Toro Company...
- Page 13 Disconnect the spark plug connector when leaving the mower. Remove the grass-collecting device and tilt it a bit to the back so that no grass will fall out. Dump the full grass-collecting device by shaking it slightly (fig. 21). © 2004 by The Toro Company...
- Page 14 - danger of injury! Mowing without the grass-collecting device is recommended for mowing high grass or if no grass collection is desired. Remove the grass-collecting device and the Recycler-plug (Fig. 22 + 23). © 2004 by The Toro Company...
-
Page 15: Maintenance And Upkeep
19365 Operate the mower only with perfect blades! Only use original TORO spare parts or parts released by TORO (reference numbers see fig. 26). © 2004 by The Toro Company... - Page 16 Do not start motor without air filter. Dust or dirt may cause serious damage to the motor. 4. Insert cleaned or new air filter insert, close cover and fasten with screw (reference number see fig. 30). 491588 © 2004 by The Toro Company...
- Page 17 5. Screw sealing plug back on. Old oil may not seep into the gound or get in the sewerage system. Collect the old oil in a larger container and deliver it to an old oil collecting place. © 2004 by The Toro Company...
- Page 18 Recommended: Champion RJ 19 LM or equivalent Adjust electrode gap to 0.75 mm (Fig. 34). Insert spark plug with packing and tighten. Tightening torque: 20 Nm If a torque wrench is not available, screw spark plug tight. © 2004 by The Toro Company...
- Page 19 Clean the mower. Check all bolts, screws and nuts. Replace damaged parts. Use only original TORO spare parts whcih you can obtain from an authorized TORO dealer. Before longer storage, empty fuel tank and let the motor run to fully consume all the fuel.
-
Page 20: Spare Parts And Troubleshooting
(Fig. 38). Always give both numbers when ordering spare parts or corre- sponding. Insert the model and serial number of your TORO lawn mower here: Model number: _______________________________________ Serial number: _______________________________________ Spare parts can be purchased at any TORO customer service by giving the model and serial number. - Page 21 5. Adjust electrode gap to 0.75 mm or mount new spark plug. 6. Vent openings in motor hood blocked. 6. Clean vent openings. 7. Cooling fins and vent holes below the fan housing are 7. Clean cooling fins and vent holes. blocked. © 2004 by The Toro Company...
- Page 22 Wheel drive turned in but mower does not 1. V belt defective. 1. Consult TORO customer service. move. 2. Free-wheel defective. 2. Consult TORO customer service. © 2004 by The Toro Company Adjusting the Bowden cable for the wheel drive...
-
Page 23: Hints On Tending The Lawn
Fertilization: For the fertilization of the lawn, a special lawn garden hoses, sprinkling systems to be installed into the soil are available, which are also manufactured by TORO. These fertilizer is to be spread on the latter in early spring. This... - Page 24 The Toro Company, 8111 Lyndale Ave. So. , Bloomington, MN 55420 - 1196, USA 95-6969...