Table of Contents
Advertisement
Charge the Battery
1) Unpack all handsets, battery packs, and
battery covers. If any battery cover is already
on the handset, press in on the notch and
slide the cover down and off.
2) Line up the red and black wires on the battery
pack with the label inside the handset.
3) Push the connector in until it clicks into place; tug gently on the wires
to make sure the battery pack is securely connected.
4) Place the cover over the battery compartment and slide it up into
place.
5) Connect the base AC adaptor to the ADAPTOR jack on the rear of the
base.
6) If you have accessory handsets, connect a charger AC adaptor to
each charger's DC IN 9V jack and set the plug into the notch as
shown.
7) Plug the other end of each adaptor into a standard 240V AC power
outlet.
8) Place a handset in the base and any
accessory handset(s) in the charger(s)
with the display(s) facing forward. The
CHARGE light on the handset(s) should
turn on.
If...
the CHARGE light
does not turn on
# Charge all handsets completely (about 15-20 hours) before using
them.
6
INSTALLING YOUR PHONE
Try...
• reseating the handset
• checking the AC adaptor connection
• seeing if the outlet is controlled by a wall switch
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the XDECT 8355 Series and is the answer not in the manual?
Questions and answers
phone 1 shows out of range
The Uniden XDECT 8355 Series phone shows "Out of Range" when the handset cannot get a signal from the base. This can happen if the handset is too far from the base, if the base is not powered on, or if there is interference. The LCD may display messages like "Out of Range," "Check Base Power," or "Move toward base."
This answer is automatically generated
How to listen to the caller leaving a message
How do I stop the red light blinking when there are no messages