Refilling With Coolant - KTM 125 SX Owner's Manual

COOLING SYSTEM

Refilling with coolant

x
15.8
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
–
Avoid contact between coolant and skin, eyes and clothing. If it gets into your eyes, rinse immediately with water and con-
tact a doctor. Wash affected skin areas immediately with soap and water. If coolant is swallowed, contact a doctor immedi-
ately. Change clothes that have come into contact with coolants. Keep coolant out of the reach of children.
(All 125/150 models)
–
Remove screw
–
Completely drain the coolant.
–
Mount screw
Guideline
Drain plug, water pump cover
601186-11
(All 250/300 models)
–
Remove screw
–
Completely drain the coolant.
–
Mount screw
Guideline
Drain plug, water pump cover
601187-11
(All 125/150 models)
–
Make sure that screw
B00071-10
(All 250/300 models)
–
Make sure that screw
B00072-10
–
Position the motorcycle upright.
–
Fill the radiator completely with coolant.
Coolant
–
Mount radiator cap
–
Run the engine until it is warm.
–
Check the coolant level. (
B00073-10
. Remove radiator cap .
 
with a new seal ring and tighten it.

M10x1
. Remove radiator cap .
 
with a new seal ring and tighten it.

M10x1
is tightened.

is tightened.

1.2 l (1.3 qt.) Coolant (
Coolant (mixed ready to use)
(
.

p. 73)
15 Nm
(11.1 lbf ft)
15 Nm
(11.1 lbf ft)
p. 113)
p. 113)
74