Rear Panel - Samsung MX-J630 User Manual

Rear Panel

1
2
3
4
1. 2.0 CH Speaker Connector Terminals
The speaker connector terminals are located
on the rear of the system.
1. To ac hieve the correct sound quality, insert
the speaker connector cables identified below
into the correct speaker terminals on the back
of the system.
• Left speaker (marked L).
• Right speaker (marked R).
2. ONLY FOR SERVICE
• This jack is for service only. Please do not
use.
3. AUX IN Terminals
1. Use an Audio Cable (not supplied) to connect
AUX IN on the product to Audio Out on an
external analog component.
• Be sure to match connector colors.
• If the external analog component has only
one Audio Out jack, connect to either the
left or right terminal.
• Press the TUNER/AUX button on the
main unit or press the AUX button on the
remote control to select the AUX input.
• When the unit is in AUX mode, if none of
the buttons are pushed for more than 8
hours, the power will automatically turn
off.
4. FM Antenna Connector Terminal
1. Connect the FM antenna (supplied) to the FM
Antenna jack.
2. Slowly move the antenna wire until you find a
location where reception is good, then fasten it
to a wall or other rigid surface.
3. If reception is poor, you may need to install an
outdoor antenna. To do so, connect an outdoor
FM antenna to FM antenna jack on the rear
of the system using a 75Ω coaxial cable (not
supplied).
7 6
English English