Page 1
2-in-1 cordless li-ion grass Trimmer/edger Taille-haie/tondeuse 2 en 1 sans fi l li-ion podadora / bordeadora de césped sin cables “2 en 1” con batería de iones de litio Wg151.5 Helpline numBeR Helpline numBeR 1-866-354-woRx (9679)
Page 5
1. ReaR Handle 2. auxiliaRy Handle 3. Telescopic sHafT 4. locking collaR 5. auxiliaRy Handle locking leveR 6. safeTy guaRd 7. floweR guaRd 8. edgeR wHeel 9. line cuTTeR 10. BaTTeRy pack 11. TRimmeR Head coveR (see fig m2) 12. cap Release laTcH (see fig m2) 13.
TECHNICAL DATA Voltage No load speed 8500/min Cutting diameter 10”(250mm) Line diameter 0.065”(1.65mm) Machine weight 5.4lbs(2.4kg) ACCEssorIEs safety guard charger Battery pack edger wheel wall mounts We recommend that you purchase your accessories from the same store that sold you the tool. Use good quality accessories marked with a well-known brand name.
sAFETY INsTrUCTIoNs periodically and replace if damaged. Keep handles dry, clean, and free from oil and waRning! When using electric grease. gardening appliances, basic safety 13) Check Damaged Parts - Before further use precautions should always be followed to of the appliance, a guard or other part that reduce the risk of fire, electric shock, and is damaged should be carefully checked personal injury, including the following:...
Page 8
sYMBoLs 2) Do not dispose of the battery(ies) in a fire. The cell may explode. Check with local codes for possible special disposal Warning instructions. 3) Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may Read the manual cause damage to the eyes or skin.
Page 9
AssEMBLY 3. How To cHaRge youR BaTTeRy (see fig d) 1. assemBly of THe safeTy guaRd Connect the battery charger to the power (see fig a) supply and the green light (18) will illuminate. Fix the safety guard to the trimmer head Slide the battery pack into the charger to make making sure the sides are located into the the connections.
trimmer has been switched off; wait until into eyes and face and cause blindness or other it has completely stopped then lay down serious injury. When operating unit, check for the tool. the following: Wear eye protection and heavy clothing. Hold 6.
this is quit normal. After about 5 seconds the waRning! Take approximately 15ft line will be cut to the correct length and the (4.5m) of line. Insert 5/8”(15mm )of noise will reduce as the motor receives full line into the spool holes and wind line in the speed.
Wipe clean with a dry cloth. • Tool and or battery failure caused by the Always store your power tool in a dry place. use of non WORX branded accessories and or Keep the motor ventilation slots clean. Keep all parts working controls free of dust.
Need help?
Do you have a question about the Wg151.5 and is the answer not in the manual?
Questions and answers