Troubleshooting; Technical Specifications - LAVAZZA A MODO MIO Operating Instructions Manual
Espresso coffee machine
Hide thumbs
Also See for A MODO MIO:
Table of Contents
Advertisement
Available languages
Available languages
EN
Problem encountered
Machine does not turn on.
Power light
is off after having
pressed the start-up/stand-by button.
The machine requires a lot of time to
heat up.
The machine is very noisy.
Red flashing light
.
The coffee flows out too fast and no
creamy froth forms on the surface.
No coffee flows out or it just drips out
slowly.
• Nominal Voltage - Power Rating - Power Supply:
See label on the appliance
• Measurements:
Height
253 mm
• Weight: approx. 2.8 kg
• Water tank: 0.5 L - Removable type
TROUBLESHOOTING
Possible causes
» Machine is not connected to the power
source.
» The machine has limescale build-up.
» No water in the tank.
» Water tank fitted incorrectly or
absent.
» Coffee knob in wrong position.
» Capsule already used.
» Dispensing spout is clogged.
TECHNICAL SPECIFICATIONS
Width
Depth
145 mm
290 mm
Client Service Lavazza A MODO MIO
0800 599 9200
Fax. +44 (0)1895 209 778 e-mail: info@lavazzamodomio.co.uk
Solution
» Connected the machine to the power source.
» Contact customer service.
» Descale the machine.
» Top up the tank with fresh drinking water.
» Fit the water tank correctly.
» Turn the coffee knob to the stop position.
» Contact customer servicea.
» Replace the capsule inside the capsule holder drawer
with a new one.
» Clean the coffee dispensing spout
(see MAINTENANCE AND CLEANING).
• Housing materials: Thermoplastic
• Cable Length: 0.8 m
• Thermo fuses
• Instantaneous aluminum boiler with temperature probe
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the A MODO MIO and is the answer not in the manual?
Questions and answers
The buttons on the machine make coffee but only a very small amount which means to get a cup of coffee you have to push the button over and over maybe 25 times to get a cup of coffee.
The LAVAZZA A MODO MIO machine may only dispense a small amount of coffee with each button press due to a clogged dispensing spout. Cleaning the coffee dispensing spout slowly, as mentioned in the maintenance and cleaning instructions, can help resolve this issue.
This answer is automatically generated
The capsule holder draw is jammed. How can I remove it?
To remove a jammed capsule holder drawer from a Lavazza A Modo Mio machine, follow these steps:
1. Ensure the machine is turned off and unplugged for safety.
2. Try gently pulling the capsule holder drawer out.
3. If it is stuck, check if a used capsule is causing the blockage.
4. If necessary, move the coffee knob to the stop position and ensure the water reservoir is filled to the MAX level.
5. If power was interrupted during the cycle, restore power and try again.
6. Avoid using force to prevent damage to the machine.
If the issue persists, contact Lavazza A Modo Mio Customer Service for assistance.
This answer is automatically generated