Handlebar Position; Adjusting The Handlebar Position - KTM Freeride 250 R EU Owner's Manual

11 TUNING THE CHASSIS
11.14

Handlebar position

11.15

Adjusting the handlebar position

Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
On the upper triple clamp, there are two holes at a distance of
Hole distance
The holes on the handlebar supports are placed at a distance of
Hole distance
The handlebar supports can be mounted in four different positions.
M01029-10
–
Remove screws
it to one side.
Info
Cover the components to protect them against damage.
Do not bend the cables and lines.
–
Remove screws
–
Move the handlebar supports into the desired position. Mount and tighten

screws
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
M01029-11
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws
Guideline
Screw, handlebar clamp
Info
Make sure the gap width is even.
15 mm (0.59 in)

3.5 mm (0.138 in)


. Remove the handlebar clamps. Take off the handlebar and lay

. Take off the handlebar supports.
.
M10

to each other.

from the center.
40 Nm Loctite
(29.5 lbf ft)

and tighten evenly.
M8 20 Nm
(14.8 lbf ft)
37
® 243™