Cub Cadet BV428 Operator's Manual

4-Cycle Suitcase Blower/Vacuum
Removing Unit From Carton Assemble The Unit
1 1 2
Remove all contents from Insert upper blower tube
the carton. into blower outlet and turn
clockwise until it locks into
place.
Assemble The Unit Starting The Unit
10 X
5
6
Place unit on a level surface. Press primer bulb 10 times,
Fill fuel tank.
or until fuel is visible
Starting The Unit
1 9 10
DO NOT squeeze throttle Pull rope 5 times.
control.
IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING THE UNIT.
NEED HELP?
769-08089 P00
BV428
Operator's Manual
3
Place the lower blower tube
onto upper blower tube and
turn clockwise until it locks
into place.
Primer
Bulb
7
Move choke lever to
Position 1.
5 X
11
Move choke lever to
Position 2 .
Call 1-877-282-8684 in U.S. or 1–800–668–1238 in Canada
No Tools Required
for Blower Assembly*
4
Place the unit on a level
surface, remove the oil plug
from the crankcase, and pour
the entire bottle of oil into the
fill hole.
Lower Blower Tube
8
Crouch in starting position.
3-5 X
12 13
Pull rope 3-5 times to start Continue to squeeze
engine. Squeeze throttle throttle. Move choke lever
control and allow unit to to Position 3.
warm up for 30 - 60
seconds.
Throttle Control
On/ Off Switch
Blower Outlet
Upper Blower Tube
Oil Plug
*For vacuum assembly, refer to
the Assembly section of the
operator's manual.
14
Continue to squeeze
throttle. Warm unit for an
additional 60 seconds to
complete warm-up. Unit
may be used during this
time.
DIDN'T START?
Repeat these instructions.
IF engine fails to start after 2 attempts,
move choke lever to position 3 and pull
the starter rope until engine starts
IF unit still fails to start, refer to operator's
manual for additional starting and
troubleshooting information
Primer Bulb
Starter Rope
03/12