Cub Cadet RZT S series Operator's Manual page 14

Ignition Switch Module
WARNING!
leave a running
machine unattended.
Always disengage PTO,
set parking brake, stop
engine and remove key
to prevent unintended
starting.
To start the engine, insert the key
into the ignition switch and turn
clockwise to the START
Release the key into the NORMAL MOWING MODE
once the engine has fired.
To stop the engine, turn the ignition key counterclockwise to the
STOP position.
CAUTION:
both Safety Interlock Switches and Starting The
Engine in the Operation section of this manual for
detailed instructions regarding the Ignition Switch
Module and operating the tractor in REVERSE
CAUTION MODE
PTO Knob
The PTO (Power Take-Off) knob is located on the
RH console to the right of the operator's seat.
The PTO knob operates the electric PTO
clutch mounted on the bottom of the engine
crankshaft. Pull the knob upward to engage
the PTO clutch, or push the knob downward to
disengage the clutch.
The PTO knob must be in the "disengaged"
position when starting the engine.
Fuel Tank Cap
The fuel tank cap is located on the left console. Turn the fill cap
to remove. Always re-install the fuel cap tightly onto the fuel tank
after removing.
WARNING!
engine is running. If the engine is hot from recently
running, allow to cool for several minutes before
refueling. Highly flammable gasoline could splash
onto the engine and cause a fire.
14 S 4— c
ection ontrolS
Never
position.
Prior to operating the tractor, refer to
.
Never fill the fuel tank when the
& F
eatureS
Throttle/Choke Control (If so equipped)
The throttle/choke control is located on the RH
console to the right of the operator's seat. When set
in a given position, a uniform engine speed will be
maintained.
• Push the throttle/choke control lever forward
to increase the engine speed. The tractor is
designed to operate with the throttle/choke
control in the FAST
tractor is being driven and the mower deck is
engaged.
• Pull the throttle/choke control lever rearward
position to decrease the engine speed.
• When starting the engine, push the control
lever fully forward into the CHOKE
• After starting and warming the engine, move
the control lever rearward until you feel it
move past the choke detent.
Throttle Control (If so equipped)
The throttle control is located on the RH console
to the left of the hour meter/indicator panel. When
set in a given position, a uniform engine speed will
be maintained.
Push the throttle control handle forward to
increase the engine speed. The tractor is designed
to operate with the throttle control in the fast
position (full throttle) when the tractor is being
driven and the mower deck is engaged.
Pull the throttle control handle rearward to
decrease the engine speed.
Choke Control (If so equipped)
The choke control is located on the RH console to
the right of the hour meter/indicator panel .The
choke control determines the position of the engine
choke. Pull the knob out to choke the engine; push
the knob in to open the choke.
Forward Drive Pedal
The forward drive pedal is located on the right side
of the tractor, along the running board. Press the
forward drive pedal forward to cause the tractor to
travel forward. Ground speed is also controlled with
the forward drive pedal. The further forward the
pedal is pivoted, the faster the tractor will travel. The
pedal will return to its original position when it's not
pressed.
Reverse Pedal
The reverse drive pedal is located on the right side of
the tractor along the running board. Ground speed
is also controlled with the reverse drive pedal. The
further downward the pedal is pivoted, the faster the
tractor will travel. The pedal will return to its original
position when it's not pressed.
CHOK E
FAST
position when the
position.
SLOW
FAST
SLOW