Making And Changing Basic Settings - Beurer GL 50 Instructions For Use Manual

4.2 Making and changing basic settings

1
Setting the date and time
Note
You must set the date and time. Otherwise, you will not be able to save your measured values
correctly with a date and time and access them again later.
The time can be displayed in 12-hour format or 24-hour format.
1. Switch on the blood glucose monitor by briefly pressing and
holding the scroll wheel.
2. Rotate the scroll wheel until the arrow is pointing towards
"settings", then press the scroll wheel.
3. Rotate the scroll wheel until the arrow is pointing towards
"date/time", then press the scroll wheel.
4. Set the year by rotating the scroll wheel, then press the scroll
wheel.
5. Use the same procedure to set the month, day, 24 h or 12 h
mode, hour and minute.
6. To save the settings, rotate the scroll wheel until the arrow is
pointing towards "save" and confirm by pressing the scroll
wheel.
2
Setting the timer
You can set a timer on the blood glucose monitor. An acoustic signal sounds when the timer
elapses. To set a timer, proceed as follows:
1. Switch on the blood glucose monitor by briefly pressing and
holding the scroll wheel.
2. Rotate the scroll wheel until the arrow is pointing towards
"settings", then press the scroll wheel to confirm.
Beurer GL50 evo mg/dL
• all values
• average
• settings
back
• timer
• alarm
• date/time
• bluetooth on/off
year 2015
month 10
days 21
24h/12h mode 24h
24h/12h mode 24h
hour 12
minute 00
save
• all values
• average
• settings
back
15