Battery Charging - IKEA FIXA Instructions Manual

when it is running but not actually doing
the job, as this may significantly reduce
the exposure level over the total working
period.
Protect yourself against the effects of
vibration by maintaining the tool and its
accessories, keeping your hands warm,
and organizing your work patterns.
DECLARATION OF CONFORMITY
We declare under our sole responsibility
that this product, FIXA hammer drill Li-Ion
14.4V, is in conformity with the following
standards or standardized documents:
EN 60745-1, EN 60745-2-6, EN 55014-1,
EN 55014-2, EN 61000-3-2, EN 61000-3-
3, EN 60335-1, EN 60335-2-29, EN 62233
in accordance with the provisions of the
directives 2006/42/EC, 2004/108/EC,
2006/95/EC, 2002/96/EC, 2011/65/EC.
Technical documentation at: IKEA of
Sweden AB, Box 702, Tulpanvägen 8,
SE-343 81 Älmhult, SWEDEN.
The undersigned is responsible
for compilation of the technical
documentation and makes this declaration
on behalf of IKEA of Sweden AB.
Christina Niemelä Ström
Business Area Manager
IKEA of Sweden AB
ASSEMBLY
Before any work on the machine
(e. g., maintenance, tool change,
etc.) as well as during transport and
storage, set the rota tional direction
switch to the centre posi tion.
Unintentional actuation of the On/Off
switch can lead to injuries.

Battery charging

Charging your hammer drill
Charging your hammer drill
When the charger is connected to the
electricity supply, the red diode on the
hammer drill lights up. The diode lights up
while the battery is being charged (13).
Under normal conditions of use the
hammer drill can be recharged several
hundred times.
ATTENTION! The recharging process
generates heat in the battery.
Note: The battery that is supplied with
the hammer drill has been charged for
test purposes only and must be fully
charged before first time use.
First read the safety instructions and then
follow the loading instructions. Insert the
charge connector (15) into the socket
(13) in the hammer drill. Then connect
the charger's transformer to the electricity
supply.
Make sure that there are no knots or
sharp bends in the cable.
The charger's transformer and the battery
have been designed to be used together.
NEVER use this charger to recharge
cordless tools or batteries from other
manufacturers. The battery will gradually
9