Congratulations on choosing the R 80 / R 120 engine type. The HE Paramotores engine type R 80 / R 120 have been developed exclusively for use in paramotoring, which must only be run mounted with specific propellers, using adequate oil type and fuel.
Observation of the engine speed............. 9 Operating instructions for HE engines type R 80 and R 120 ....10 Technical description of the HE engines type R 80 and R 120 .... 10 Type of engine ................. 10 Ignition unit ................10 iii.
1. Installation instructions for HE Engine Type R 80 and R 120 a. General precaution and safety information for engine installation Warning: For the best possible engine operation, compliance with the following advice regarding installation of engine and equipment is required.
Note: this operation is better conducted when the engine has been previously warmed up in order to liquefy the oil. Note: use a syringe to fill the reduction compartment. Confidencial HE Paramotores Página 6 30/03/2007...
Check that all the gaskets are properly fitted onto the laminar entry box and carburettor installation plat. For the R 80 engines, make sure that the venting hole on the side of the laminar entry box and carburettor installation plat is clear and clean.
2. Attention: Do not over stress the springs 2 when fitting them. Attention: Condition of the exhaust system installation must be verified before each flight. Confidencial HE Paramotores Página 8 30/03/2007...
To determine the best possible transmission ratio, the use of a rev-counter is required for observation of the speed limits. Note: HE Paramotores offers as an accessory the following indicating instrument: Tiny-Tach inductive rev counter. Note: This instrument is operating via an integrated battery. At engine start the readings of the connected sensors (inductive pick-up for engine speed (r.p.m.) will be displayed).
2. Operating instructions for HE engines type R 80 and R 120 a. Technical description of the HE engines type R 80 and R 120 i. Type of engine Single cylinder two cycle engine with reed valve controlled inlet. Mixture lubrication is achieved by adding oil to the gasoline in a specified mixing ratio.
Page 11
Attention: Ensure that no contamination enters the fuel tank and the carburettor. Attention: Unleaded fuel has a limited storage life. Store only the quantity of fuel in a container which will be needed in the near future. Confidencial HE Paramotores Página 11 30/03/2007...
The engine abates while leaving it at idle for ten sec. and it revs up slowly, excess of smoke. R 80 and R120: Our carburettor is provided with a starter for the very first starting (cold starting). Flip up switcher A in position 2 for starting, in position 1 for functioning.
Page 13
The C screw sets the revs at idle, by opening the butterfly valve (for additional information please contact your local distributor). If the idle is high, turn the screw in an anti clockwise direction. If the idle is low, turn the screw in a clockwise direction. Confidencial HE Paramotores Página 13 30/03/2007...
Warning: HE Paramotores does not take any responsibility for bad handling and dangerous behaviours with its engines. Attention: HE engines type R 80 and R 120 have been developed only for paramotoring purposes. Any other use will not be covered by the engine’s guarantee.
System of unloading to resonance. Helicoïdal gear reduction Manual pull start In flight consumption with at 9000 revs, 4 litres/hour Power /torque table engine 6000 5,91 6,08 7200 10,44 10,64 8500 17,5 13,05 12,92 9700 15,20 Confidencial HE Paramotores Página 15 30/03/2007...
Page 16
R 80 Static Thrust Motor R 80 Reduction 1:4 Twin blade propeller in wood 49x26 R Test conditions T 12°C - P 1048 Mb - UR 45% Loc. Madrid 04/11/2004 Altitude 700 m Consumption in Engine revs 1/hr in thrust (*)
It is nearly always an excess of fuel – the engine has been flooded. Unlike a lot of paramotor engines the R 80 has it’s spark plug “head up” so it’s not prone to flooding. Over zealous use of the fuel primer pump will, however, flood it and it won’t start no matter how many times you pull the cord (!) If the engine has become flooded, simply remove and wipe clean the spark plug.
Page 18
The best way to run in your new R 80 is to vary the load on it during the initial running minutes for example: Start &...
Page 19
In case of overheating it is advisable to check the head screws to verify the seal of the motor head, see locking torques. Usually a loss of seal can be perceived by dull strokes at starting or by oil leakage, once the air conveyer is removed. Confidencial HE Paramotores Página 19 30/03/2007...
Check all bolts and lock nuts in general and in particular check the nuts on the base of the exhaust pipe. Do not over tighten the exhaust manifold bolts. Check, whilst engine warm, the four bolts on top of the cylinder head. Pressure of tightness should be 12 N.M (8.85 lbf.ft) Confidencial HE Paramotores Página 20 30/03/2007...
Detach carburettor, drain fuel from fuel system and close carburettor openings to ensure that no dust or dirt can enter. Close intake and exhaust port of engine so that they are air tight with adhesive tape. Apply oil on exhaust systems to prevent corrosion. Confidencial HE Paramotores Página 21 30/03/2007...
• the carburettor gasket is broken or badly mounted • replace the diaphragms* * must be done when fuel swiftly goes back to the fuel tank when switching off the engine Confidencial HE Paramotores Página 22 30/03/2007...
Page 23
Confidencial HE Paramotores Página 23 30/03/2007...
HE Paramotores distributors from the date of sale to the first consumer, every HE Paramotores R 80 and R 120 engine, sold as new and unused, and delivered by an authorised HE Paramotores distributor for a period of the earliest of: Note: 6 consecutive months for private use owners;...
Note: Damage caused by electrolysis. Note: Cold seizure and scuffing. Note: Use of gear reduction not designed by HE Paramotores. Note: Use of propeller not referenced by HE Paramotores. Note: Losses incurred by the paramotor engine owner other then the parts...
HE Paramotores reserves the right to modify its warranty policy at any time, being understood that such modification will not alter the warranty conditions applicable to paramotor engines sold while the above warranty is in effect. vi. Consumer assistance procedure...
Gearbox: ……………………… Reduction 1 - ……………………… Inv. –no: ……………………. Date of purchase: …………………. Warranty expires: ……………………………………………………… Seller: ……………………………………………………………………… Buyer: ……………………………………………………………………… I have read and understood the operator’s manual in its entirety carefully followed described break-in procedure. Date: ……………………………. Signature: Confidencial HE Paramotores Página 27 30/03/2007...
Page 28
Gearbox: ……………………… Reduction 1 - ……………………… Inv. –no: ……………………. Date of purchase: …………………. Warranty expires: ……………………………………………………… Seller: ……………………………………………………………………… Buyer: ……………………………………………………………………… I have read and understood the operator’s manual in its entirety carefully followed described break-in procedure. Date: ……………………………. Signature: Confidencial HE Paramotores Página 28 30/03/2007...
Reporting In case of a malfunction or a defect the form below should be filled out and should be sent to the responsible HE Paramotor authorized distributor. Confidencial HE Paramotores Página 29 30/03/2007...
Need help?
Do you have a question about the R 80 and is the answer not in the manual?
Questions and answers