Advertisement
Caution-Read This Before Operating Your SS-30
Place the SS-30 on a solid stand, such as a piano or an Electone Organ to play
it.
Do not place the SS-30 where it will be exposed to direct sunlight, excessive
heat (for instance over a radiator), cold, moisture, or dust.
When connecting the power cord to the socket, do not place many loads on
one electric outlet. Put the cord into the outlet completely after confirming
that the power switch of the instrument is off.
* Be careful not to lose the power cord.
Read "Connection Diagram" on page 6 to make connections properly. To
prevent the speaker from breaking, make sure that each power switch is off
when wiring the instrument.
Put the wiring cord in place. To remove the plug, hold the plug firmly to take
it out to prevent the cord from breaking or being short-circuited.
Try to turn off the power switch after playing.
Clean the keyboard, etc., with a dry cloth only. Never use volatile solvents
such as thinner; they will fade or deform the finish.
When the SS-30 must be moved for concert and house-moving, pack it well
enough to withstand any shock. It is recommended that you keep the card-
board boxes and packing used for the SS-30 you bought so that you may use
them for such an occasion.
*
At that time put the power cord in the boxes.
If you will find any trouble, check for each connection of the device again.
If it is found difficult to mend it for all that, contact the YAMAHA dealer from
whom you purchased your instrument or any other YAMAHA dealers
nearby. ( Never touch the inside circuitry.)
3
Advertisement
