Entering Invalid Engine Mode; Entering Recovery Mode; Accessing The Network Se Menu; Service Engineer Menu - Lexmark CX310 Service Manual

Entering Invalid engine mode

This mode is used if the machine has invalid code and needs the correct code loaded. After entering this mode, the
firmware code can be updated.
1
Turn off the printer.
2
Press and hold 3, 4, and 6 simultaneously.
3
Turn on the printer.
4
Release the buttons after 10 seconds.

Entering recovery mode

This mode will allow the printer to boot from a secondary set of instructions to allow a code flash to the printer. Code
can be flashed from a PC via USB.
1
Turn off the printer.
2
Press and hold the 7, 2, and 8 buttons simultaneously.
3
Turn on the printer.
4
Release the buttons after 10 seconds.

Accessing the Network SE menu

This menu contains settings for fine tuning the communication settings for the network interfaces and protocols.
1
Touch Select and Right.
2
Navigate to Networks/Ports > Standard Network > Std Network Setup.
3
Press and hold 6, 7, and 9 simultaneously.

Service Engineer menu

Accessing the service engineer (SE) menu

From a Web browser on a host PC, add /se to the printer IP address.

Service engineer (SE) menu

This menu should be used as directed by the next level of support.
Top level menu
Print SE Menus
General
Intermediate menu
Copyright — Displays copyright information
Service menus
224
7527