Fitting The Collection Bag - Gardenline 52754 User Manual

Fitting the Collection Bag

WARNING: Never operate the vacuum without collection bag attached.
Serious personal injury could be the result if the blower vac is used without
the bag fitted.
IMPORTANT. Before using this appliance as a vacuum, ensure the correct
vacuum tubes are in position as per the instructions on the previous page,
and the collection bag zip is done up before fitting.
NOTE: Always make sure the collection bag (10) zipper is closed when the
vacuum function is in use.
For use as a vacuum, the collection bag (10) must be fitted.
The collection bag (10), via the bag tube (7), fits on to the discharge port (24)
of the blower vac housing, where the blow tubes are fitted when used in
blowing operation.
If the blow tubes are fitted, these need to be removed by removing the
toolfree blower lock knob (25), then rotating the tube, in a clockwise
direction, as far as possible and then pulling the full blow tube/s assembly
off the blower (Fig M).
1. Align the arrows on the blower vac housing and
on the bag tube (Fig N).
2. Align the collection bag tube (7) onto the
discharge port (24) by aligning the external pins
protruding from the port with the 2 channels
on each side of the bag tube (7) . Then push the
bag tube (7) onto the discharge port (24) outlet
housing as far as possible (Fig N).
18
e-mail: help@powertoolsupport.com
MODEL: №. EBV245A • 08/2016 • 52754
24.5cc 4 Stroke Petrol Blower Vacuum
M.
N.
AFTER SALES SUPPORT
1800 909 909
(toll free)