Headlamp Washer Switch - Mitsubishi ASX Manual

Instruments and controls
NOTE
l
The rear window wiper will automatically per-
form several continuous operations if the gear-
shift lever or the selector lever is put in the
"R" position while the windscreen wipers or
the rear window wiper is operating. (automat-
ic operation mode).
After the automatic operation, the rear win-
dow wiper will stop operating if the knob is
in the "OFF" position. If the knob is in the
"INT" position, the rear window wiper will
return to the intermittent operation.
It is possible to set the rear window wiper to
perform the automatic operation only if the
gearshift lever or the selector lever is put in
3
the "R" position while the rear window wip-
er is operating with the knob in the "INT" po-
sition.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Author-
ized Service Point.
l If the knob is in the "OFF" position, turn the
knob to the "INT" position twice quickly to
operate the rear window wiper continuously.
(continuous operation mode)
Turn the knob to the "OFF" position to stop
the rear window wiper continuous operation.
l
The interval for intermittent operation can be
adjusted.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Author-
ized Service Point.
On vehicles equipped with MITSUBISHI
Multi-Communication System
screen operations can be used to make the ad-
justment. Refer to the separate owner's man-
ual for details.
3-56

Headlamp washer switch*

The headlamp washer can be operated with the ig-
nition switch or the operation mode in ON or ACC
and the lamp switch at the "
Push the button once and the washer fluid will be
sprayed on to the headlamps.
NOTE
l If the ignition switch or the operation mode
is in ON or ACC and the headlamps are on,
the headlamp washer operates together with
the windscreen washer the first time the wind-
screen washer lever is pulled.
(MMCS),
Precautions to observe when using wip-
ers and washers
E00507800289
l
If the moving wipers become blocked by ice
or other deposits on the glass, the motor may
" position.
burn out even if the wiper switch is turned to
OFF. If obstruction occurs, park your vehicle
in a safe place, turn off the engine, and clean
the deposits from the glass so that the wipers
operate smoothly.
l Do not use the wipers when the glass is dry.
They may scratch the glass surface and the
blades wear out prematurely.
l Before using the wipers in cold weather,
check that the wiper blades are not frozen on-
to the glass. The motor may burn out if the
wipers are used with the blades frozen onto
the glass.
l Avoid using the washer continuously for
more than 20 seconds. Do not operate the
washer when the fluid reservoir is empty.
Otherwise, the motor may burn out.
l Periodically check the level of washer fluid
in the reservoir and refill if required.
During cold weather, add a recommended
washer solution that will not freeze in the
washer reservoir. Failure to do so could re-
sult in loss of washer function and frost dam-
age to the system components.
E00510000070