Nokia rx-34 Service Manual page 85

RX-34
Service Tools and Service Concepts
Issue 2
FS-29
FS-29 has the following features:
• Provides galvanic connection to terminal test pads
• Provides standardized interface towards Control Unit
• Provides RF connection using galvanic connector or coupler
MJ-103
MJ-103 is meant for component level troubleshooting.
The jig includes an RF interface for WLAN and Bluetooth. In addition,
it has the following features:
• Provides mechanical interface with Engine module
• Provides galvanic connection to all needed test pads in module
• Multiplexing between USB and FBUS media, controlled by Vusb
• UI test interface
• MMC interface
• Audio components: IHF, MIC, earpiece
• Connector for control unit
• Access for USB connector
Note: XRS-6 RF cable should be connected to SMA connector
of CA-58RS cable.
PCS-1
The PCS-1 power cable (DC) is used with a docking station, a module
jig or a control unit to supply a controlled voltage.
PKD-1
SW security device is a piece of hardware enabling the use of the
service software when connected to the parallel (LPT) port of the PC.
Without the device, it is not possible to use the service software.
Printer or any such device can be connected to the PC through the
device if needed.
COMPANY CONFIDENTIAL
Copyright © 2007 Nokia. All rights reserved.
Flash adapter
Module jig
Power cable
SW security device
Page 4 –9