Carburetor Removal - Honda VTR1000F Service Manual
Hide thumbs
Also See for VTR1000F:
- Owner's manual (149 pages) ,
- Owner's manual (148 pages) ,
- Owner's manual (148 pages)
Table of Contents
Advertisement
CARBURETOR REMOVAL
Drain the coolant (page 6-5).
Remove
the air cleaner housing (page 5-4).
NOTE:
When the carburetors will not be serviced,
remove
the carburetor assembly with the air cleaner hous-
ing attached to
prevent
the threaded holes in the
carburetor from damaging.
Disconnect the throttle sensor 3P (white) connector.
ED, G type:
Remove
the throttle sensor wire from
the clamp.
Loosen the carburetor insulator band bolts.
NOTE:
Insert the screwdriver through the hole in the heat
guard to loosen the front carburetor insulator band
bolt.
Remove
the carburetor assembly from the insula-
tors.
Remove
the throttle cables from the cable stay and
disconnect them from the throttle drum.
Disconnect the water inlet and outlet hoses from
the carburetor heaters.
FUELSVSTEM
5-5
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the VTR1000F and is the answer not in the manual?
Questions and answers
Seat won’t lock on 2001 vtr1000
The seat lock on a 2001 Honda VTR1000F may not work due to several possible reasons:
1. Faulty or Incorrect Key – Ensure you are using the correct key and that it is not worn or damaged.
2. Lock Mechanism Issue – Dirt, debris, or rust inside the seat lock can prevent proper operation.
3. Improper Installation – If the seat lock was recently replaced, it may not be installed correctly.
4. Damaged Lock Components – Internal components of the seat lock may be worn or broken.
5. Misaligned Seat Latch – The seat latch may not be engaging properly with the lock mechanism.
To troubleshoot, clean the lock, ensure proper key usage, check for visible damage, and verify seat latch alignment.
This answer is automatically generated