Changing Oil And Filter - MerCruiser Sterndrive TDI 3.0L User Manual

2. Add the specified oil to bring the oil level up to, but not over, the maximum mark on the dipstick.
a
b
c
50584
NOTE: If the engine is going to be run for an extended period of time (10–12 hours), the oil level must be in the middle of
the MIN and MAX markings indicated on the dipstick.
3.0 Liter TDI
Engine oil (with filter)
Volume difference between the minimum and maximum markings
on the dipstick
IMPORTANT: When refilling the engine with oil always use the dipstick to determine how much oil is required.
3. Install the oil fill cap.

Changing Oil and Filter

Refer to the Maintenance Schedule for the change interval. You should change the engine oil before placing the boat in
storage.
IMPORTANT: Change the engine oil when the engine is warm from operation. Warm oil flows more freely, carrying away more
impurities. Use only recommended engine oil. Refer to Specifications.
1. Start the engine and allow it to warm up to normal operating temperature.
2. Stop the engine and allow approximately five minutes for the oil to drain into the oil pan.
3. Remove the top engine cover.
4. Remove the cover of the oil filter so that the return valve opens and the used oil can flow back into the oil sump.
90-8M0070851 AUGUST 2012
eng
a - No oil required
b - Oil may be added, but do not exceed above range a
c - Oil must be added, but do not exceed above range a
Fluid Type
5W‑30 that meets VW 504
00/507 00 specifications
a - Oil filter cover
a
50598
Section 5 - Maintenance
Capacity
8.0 Liter (8.45 US qt)
1.3 Liter (1.4 US qt)
Page 55