Error Codes - Microplex SOLID F40 Operator's Manual

_______________________________________________________________________________________________

8.2.1. Error Codes

Error code
E0001
E0002
E0003
E0004
E0005
E0007
E000A
E000B
E000C
E000D
E0012
E0013
E0016
E0017
E0018
E0019
E001A
E001F
E0020
E0026
E0028
E0029
E002A
E002C
E0032
_______________________________________________________________________________________________
MICROPLEX
The following printer errors will be displayed in the panel by a
hex number only and the additional word "ERROR" .
Only a MICROPLEX authorized operator or service engineer
should address the printer problems listed in the following table
(error code E00A and so on).
Description
Front cover open
No fanfold paper on the tractor
Paper jam within the fuser unit
Paper jam behind the fuser unit
Paper jam in the paper exit
Paper Transport roller is free (knob C) or paper path is open
Cut motor does not work normally (at the front)
Cut motor does not work normally (at the rear)
Transport motor does not work normally (no up position)
Transport motor does not work normally (no down position)
Paper does not leave the fuser unit
Paper does not leave the paper exit
Position of fanfold paper is not normal
High voltage providing is not normal
Drum motor does not work normally
Surface potential is not normal (too high)
Surface potential is not normal (too low)
Flash is missing
Fuser unit is too hot
Cleaning unit is missing
Waste toner bottle is full
Waste toner bottle is missing
No toner
Toner density is not normal (too low)
LED head is too hot
Operator's Manual SOLID F40
Troubleshooting
Edition 1.1
131