12 | Installation using Outdoor Kit (BTOK)
Outdoor kit (BTOK) includes:
• Supports (2) with screws
• Sealing gasket
• Control panel shield
• Outdoor vent cap
5.2
Installing outdoor vent cap on the appliance
Replace the control panel shield
▶ Loosen the two Phillips head screws located on bottom rear of cover
(see fig. 7)
Fig. 7
Loosen the two screws
WARNING:
▶ The control panel shield must always remain closed,
except when making adjustments, to prevent
damage to heater from weather.
1. Attach the supports (A) to the appliance by fastening with the four
provided screws, as shown in fig. 8.
A
Fig. 8
Support brackets
Before mounting the outdoor kit in the appliance:
6 720 644 956 (2016/05)
A
6720644956-03.1V
2. Attach the gasket provided with the kit as shown in fig. 9.
6720645551-15.1V
Fig. 9
Gasket
3. Position the outdoor vent cap on the top of the appliance, as shown
in fig. 10
Fig. 10 Outdoor cap
Fig. 11 Screws
6720645551-11.1V
6720645551-12.1V
940 ESO