Philips 43PUH4900 User Manual page 30

ask you to select a Quick or Full installation.
Select Quick to install the channels of the package
only or select Full to install the package and all
other available channels too. We recommend a Quick
installation for subscription packages. If you have
additional satellites that are not part of your
subscription package, we recommend a Full
installation. All installed channels are put in the
channels list All.
Unicable setup
The Unicable system
You can use a Unicable system to connect the
antenna dish to the TV.A Unicable system uses one
cable to connect the satellite dish to all satellite
receivers in its system. Unicable is typically used in
apartment buildings. If you use a Unicable system, the
TV will ask you to assign a user band number and
corresponding frequency during the installation. You
can install 1 or 2 satellites with Unicable on this TV.
If you notice some missing channels after a Unicable
installation, another installation might have been
done at the same moment on the Unicable system.
Do the installation again to install the missing
channels.
User band number
In a Unicable system, each connected satellite
receiver must be numbered (e.g. 0, 1, 2 or 3 etc.).
You can find the available user bands and their
number on the Unicable switchbox. User band is
sometimes shortened as UB. There are Unicable
switchboxes that offer 4 or 8 user bands. If you select
Unicable in the settings, the TV will ask you to assign
the unique user band number for its built-in satellite
receiver. A satellite receiver cannot have the same
user band number as another satellite receiver in the
Unicable system.
User band frequency
Next to the unique user band number, the built-in
satellite receiver needs the frequency of the selected
user band number. These frequencies are mostly
shown next to the user band number on a Unicable
switchbox.
Automatic channel update
If you receive digital channels, you can set the TV to
automatically update the list with new channels.
Alternatively, you can start a channel update yourself.
Automatic channel update
Once a day, at 6 AM, the TV updates the channels
and stores new channels. New channels are stored in
the All channels list but also in the New channels list.
Empty channels are removed.
If new channels are found or if channels are updated
or removed, a message is shown at TV start up. The
TV must be in standby to automatically update
channels.
To switch off the message at start up . . .
1. Press  and select Setup and press OK.
2. Select Satellite settings and press OK.
3. Select Channel installation > Channel update
message > Off.
To switch off the Automatic channel update . . .
1. Press  and select Setup and press
2. Select Satellite settings and press OK.
3. Select Channel installation > Automatic channel
update > Off.
Start an update
To start an update yourself . . .
1. Press  and select Setup and press OK.
2. Select Search for satellite and press OK.
3. Select Update channels and follow the
instructions on screen. The update may take a few
minutes.
In certain countries, the Automatic channel update is
done while watching TV or any moment when the TV
is in standby.
Manual channel update
You can set the TV to only update the channels of a
specific satellite.
To mark satellites for updating...
1. Press  and select Setup and press
2. Select Satellite settings and press OK.
3. Select Channel installation > Automatic update
option and press OK.
4. In the list of satellites, select a satellite and
press OK to mark or unmark.
In certain countries, the automatic channel update is
done while watching TV or on any moment when the
TV is in Standby.
30
OK.
OK.