Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for HP R7000
Summary of Contents for HP R7000
-
Page 1: Installation Instructions
HPE UPS R7000 Installation Instructions Part Number: 637910-002... -
Page 2: Translated Instructions
HPE (http://www.hpe.com/support/UPSR7000_Manuals). (http://www.hpe.com/support/UPSR7000_Manuals) Overview The HPE UPS R7000 features a 4U rack-mount design and offers power protection for loads up to 7200 VA/7200 W (NA/JPN) or 6500 VA/6500 W (INTL). To benefit from the latest product enhancements, update to the latest versions of UPS firmware and software. -
Page 3: Tools And Materials
• Circuit overloading—Consideration should be given to the NOTE: The rating label on the device provides the connection of the equipment to the supply circuit and the effect class (A or B) of the equipment. Class B devices have a that overloading of the circuits might have on overcurrent Federal Communications Commission (FCC) logo or protection and supply wiring. -
Page 4: Installing The Ups
Insert screws through the rack into the mounting rail and the Install the rail reinforcement plates and tighten using hex nuts front of each mounting bracket. with captive washers included in the kit, instead of the nuts included with the rail. Install clip nuts into the rear of the rack. -
Page 5: Attaching The Ups Front Bezel
WARNING: A risk of personal injury or damage to the equipment exists. Uneven loading of equipment in the rack might cause the rack to become unstable. Install the heavier components first, and then continue to populate the rack from the bottom to the top. Install the mounting rails ("Installing the mounting rails"... -
Page 6: Reassigning The Usb Com Ports
From the COM Port Number drop down menu, select Com 1 for the USB port number, and then click OK. If COM 1 is being used by another USB port, the following message appears: This COM name is being used by another device. Using duplicate names can lead to inaccessible devices and changed settings. -
Page 7: Connecting The Network Cable
Connecting the network cable • Use tie wraps and tie wrap blocks to secure the wires tightly to the rack and the rear of the UPS. Connect a standard Ethernet cable between the network connector on the UPS Network Module and a network jack. For more information about the REPO port, see "REPO port"in the user guide. -
Page 8: Installing The Extension Bars (If Included)
Installing the extension bars (if • Connect an extension bar to any IEC-320-C19 receptacle to yield seven additional IEC-320-C13 receptacles. included) Connecting the UPS cord retention clips Charging the UPS batteries With the UPS in Standby mode, allow the batteries to charge before putting the UPS into service. -
Page 9: Connecting The Configuration Cable
Connecting the configuration cable IMPORTANT: The IP address assigned to the UPS Network Module must be fixed. If the IP address Connect the DB-9 connector on the DB-9 to RJ-45 cable to a changes: serial connector on the host computer. •... -
Page 10: Configuring The Ups Network Module Settings
Click Sign In. The UPS Network Module web interface Configuring the UPS Network Module appears. settings Use the Settings screens of the UPS Network Module web interface to configure the UPS Network Module. For more information, see the UPS Network Module user guide on the Hewlett Packard Enterprise website (http://www.hpe.com/support/HPNM_Manuals). - Page 11 © Copyright 2011, 2015 Hewlett Packard Enterprise Development LP The information contained herein is subject to change without notice. The only warranties for Hewlett Packard Enterprise products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. Hewlett Packard Enterprise shall not be liable for technical or editorial errors or omissions contained herein.