Installation instructions
for your new
CAUTION:
• Before you begin—Read these instructions, Use & Care Manual and Important Safety Instructions
completely and carefully.
• This Kit is for use on models: JE1530GW, JE1540AW/GW/WW, JE1550GW/GY/WW/WY, JES1533BW, JES1534BW,
JES1634WA/BB/WB, JE1640GA/WA/AB/GB/WB, JE1650AA/GA/WA, JE1660GA/SA/WA/GB/WB/SB, ZE1660SA/SB.
• This kit can be installed alone or over any General Electric/Hotpoint/RCA single electric wall oven.
• Do not alter or modify any part of this kit or the oven.
• Observe all governing codes and ordinances.
• Oven must be plugged into a properly grounded 3-hole, 120 volt receptacle as required by the
National Electrical Code.
• Unplug the microwave oven before attempting installation of this kit.
• Save these instructions (for Local Inspectors and Future Reference).
Parts List
1. Base Pan
2. Rear Duct
3. Top Duct
4. Trim Kit Frame
5. 2 Rear Holdown Brackets
Screws A (6 required 2 extra)
B (4 required 1 extra)
C (8 required 2 extra)
Screw A
Screw B
Screw C
Note: This kit has extra screws to prevent servicemen from spending
extra time locating a replacement in case they lose one during installation.
Cabinet Cutout Dimensions and Specifications
Allow 1-1/2" overlap on the top and bottom edges and 3" overlap on
each side of the cutout for this microwave oven trim kit.
WIDTH
HEIGHT
24-1/8"±1 ⁄ 8"
17-9/16"±1⁄16"
120 volt—60 Hertz grounded power receptacle.
For Installation Above a Built-In Oven
Microwave oven should be installed on a
3⁄8" plywood base and supported by 2x4 or
1x2 equivalent runners on all sides. Base
must be capable of supporting a minimum
of 100 lbs.
1
DEPTH
19" Min. receptacle outside cutout
21" Min. receptacle inside cutout
19-3/4"
29-3/4"
Microwave Oven
Built-In Trim Kits
JX1530MAW, JX1530MBW,
JX1530MWW, JX1530MSA
4
A
2
3
Parts Inventory
5
B
C
24-1/8"±1/8"
17-9/16"±1/16"
21" Min.
receptacle
in cabinet
19" Min.
receptacle
outside
cabinet