All rights reserved. No part of this publication may by reproduced, stored in a CONFIGURATION SETUP retrieval system or transmitted, in any form or by any means, electronics, mechanical, photocopying, or otherwise without the prior permission of Philips 3141 785 30953 Version 1.3...
E.g. 050303 Current consumption Procedure on how to upgrade the software of the DVD Portable DC-IN SUPPLY (9.0V) Download the latest software from the Philips Battery Charging Current 1.2A typ. support site. BATT. SUPPLY (7.2V) Unzipped the files and then burn it onto a CD ROM Power Off then playback the CD ROM on the DVD Portable.
Page 3
2.0 SAFTETY INSTRUCTIONS WAARSCHUWING WARNING Alle IC’s en vele andere halfgeleiders zijn All ICs and many other semi-conductors are gevoelig voor electrostatische ontladingen susceptible to electrostatic discharges (ESD). (ESD). Careless handling during repair can reduce life Onzorgvuldig behandelen tijdens reparatie kan drastically.
Page 4
2.1 ESD PROTECTION When the power supply is being turned on, you may not remove this laser cautions label. If it removes, radiation of laser may be received. PREPARATION OF SERVICING Pickup Head consists of a laser diode that is very susceptible to external static electrocity. Although it operates properly after replacement, if it was subject to electrostatic discharge during replacement, its life might be shortened.
Page 5
SAFTY NOTICE SAFTY PRECAUTIONS LEAKAGE CURRENT CHECK Plug the AC line cord directly into a 120V AC outlet (do Measure the AC voltage across the 1500 resistor. not use an isolation transformer for this check). Use an The test must be conducted with the AC switch on and AC voltmeter, having 5000 per volt or more sensitivity.
3.0 INSTRUCTIONS FOR USE , , , DVD PLAYER LAYOUT POWER/CHG Up / down / left / right cursor Power and charging indicator IR sensor Confirms selection Remote sensor SETUP ON . POWER . OFF System setup Switches the player on / off MENU Displays MENU page VOLUME...
Page 7
Remote Control , , , 7 0 - 9 Up / down / left / right cursor Numeric keypad Confirms selection 8 MUTE Muting play volume VOLUME REPEAT Volume control Repeats chapter / title / disc 9 RETURN For previous ( ) or next ( ) For VCD menu page chapters, tracks or titles ANGLE...
Page 8
4.0 MECHNICAL INSTRUCTIONS 1. Back View as Fig.1 remove 5. Remove top cover as Fig.6 Remove screws to remove base screws remove remove screws screws Fig.1 Fig.6 2. Soldered short pattern for laser diode as Fig.2 6. Disconnect the speakers and IF board Remove IF board shield as Fig.7,8.
5.0 TROUBLESHOOTING & SERVICE TIPS Procedure to change regioncode 1. Power on player and open DVD Door. 2. Press <Set Up> at Remote Control. In <Set Up Menu> select <Preferences>. 3. For PET705 - Press successively 2 1 2 2 2 5. . . 4.
Page 10
5.0 TROUBLESHOOTING & SERVICE TIPS Substitute solution for phased out Main PCB ASS’Y 994000004198 (General Service Information – BG ES – PI-06/006) The MAIN PCBA board 994000004198 is no longer support. The substitute solution is to use 994000005107 as replacement. However different IC were used on these two boards, software upgrade is NECESSARY after replacing 994000004198 by 994000005107 on the PET705.
Page 11
5.0 TROUBLESHOOTING & SERVICE TIPS Change of HV PCB ASS’Y 994000004201 and FUNCTION PCB ASS’Y 994000004202 (General Service Information – BG ES – PI-06/032) The phased out HV and FUNCTION PCBA board. The 12NC is shown as below: 994000004201 PET705 HV PCBA 994000004202 PET705 FUNCTION PCBA The phased in HV and FUNCTION PCBA board.
Page 12
5.0 TROUBLESHOOTING & SERVICE TIPS SYMPTOM: NO POWER, NO GREEN LED start Check if the power cable replace cable/ No defect, return set OK? adapter set to customer AC adapter Check if the replace connector power and play and switch unit button OK? replace MAIN go to other...
Page 13
5.0 TROUBLESHOOTING & SERVICE TIPS SYMPTOM: THE INITIAL SCREEN IS NOT DISPLAYED ON THE LCD Refer to the symptom NO start POWER, NO GREEN LED Replace broken Check if the Repair connector harness LED on the front lights up? Remove the LCD Open the top and Is the cover and plate of...
Page 14
5.0 TROUBLESHOOTING & SERVICE TIPS SYMPTOM: THE DVD DRIVE DOES NOT OPERATE WITH BATTERY start Install a good battery does the LED lights up orange while the AC adapter is connected and does the DVD drive operate OK? NOTE: - For this check, use a battery which is not fully Replace battery charged (because the LED does not light when the battery is fully charged.)
Page 15
5.0 TROUBLESHOOTING & SERVICE TIPS SYMPTOM: THE DVD DRIVE DOES NOT WORK Press the DISC cover switch at the center of the DVD player and turn on the power. Then check whether or not the optical pick- up lens of the DVD drive lights. CAUTION: start Visible laser radiation when open and interlock defeated.
Need help?
Do you have a question about the PET705/00 and is the answer not in the manual?
Questions and answers