Miter - Wen 3966 Instruction Manual

Fig. F
1
1
Fig. G
INSTALLING THE CIRCLE
CUTTING GUIDE
1. Insert the center pin into the hole
of the sliding bracket. Fix it with Lock
Knob A. This center pin will serve as
the pivot point for making circular cuts
(Fig. I).
2. Fix the sliding bar into the bearing
bracket of the upper guard assembly.
Slide it into the desired position and
secure it with tightening Lock Knob B.
10
INSTALLING THE ACCESSORY TOOLS
2
1. Install the accessory tools assembly to the frame by using M4x10
socket heat bolts (Fig. F - 1).
2. Secure the hook with a hex nut to the frame (Fig. F - 2).
3. Set the rip fence onto the table. Lock it in place with the Fence Lock
(Fig. G - 1).
NOTE: To reverse the rip fence, remove the fence from the rip fence
by loosening the four bolts holding it to the rip fence, reversing the
fence, and reattaching the bolts. (Fig. H)
2
Fig. I
ASSEMBLY
4. Set the miter gauge into the onboard storage along the
base of the bandsaw (Fig. G - 2).
5. Set the push stick on the hook (Fig. G - 3, Fig. F - B).
3
A
Fig. H
B
Fig. J