NorthStar VHF Marine Radio Explorer 721EU Operation And Installation Manual page 19

2-6-3 Time Format Options (TIME FORMAT)
Time can be shown in 12 or 24 hour format.
GPS/DATA
MANUAL
> SETTING
1. Select GPS/DATA, then SETTING.
2. Select TIME FORMAT.
3. Select 12 Hr or 24 Hr as desired. In this example, 12 hour format has been selected so the LCD shows
the AM or PM suffix.
2-6-4 Time Display Options (TIME DISPLAY)
If you've entered the time manually as described in the previous sections, the time is shown ALWAYS with
the prefi x M.
However, if the vessel's position is being updated through a GPS navigation receiver, you can switch the time
display ON or OFF as follows:
GPS/DATA
TIME OFFSET
TIME FORMAT
> TIME DISPLY
If the time display is set ON, course and speed data are NOT displayed on the LCD (see
section 2-5-6).
2-6-5 Position Display Options (LL display)
If you've entered the vessel position manually as described in the previous section, the vessel position is
shown ALWAYS with the suffi x M.
However, if the time is being updated through a GPS navigation receiver, you can switch the vessel position
display ON or OFF as follows:
GPS/DATA
TIME FORMAT
TIME DISPLY
> LL DISPLAY
2-6-6 Course & Speed Display Options (COG/SOG)
Use this option to display course over ground (COG) and speed over ground (SOG) data on the screen.
GPS/DATA
TIME DISPLY
LL DISPLY
> COG/SOG
If COG/SOG is set ON, the time is NOT displayed on the screen (see section 2-5-4).
SETTING
TIME OFFSET
> TIME FORMAT
TIME DISPLAY
TIME DISPLY
ON
> OFF
LL DISPLAY
ON
> OFF
COG/SOG
> ON
OFF
Northstar Explorer VHF Series: 721US, 721EU Operation and Installation Manual
TIME FORMAT
> 12 Hr
24 Hr
07:15AM LOC
1. Select GPS/DATA, then SETTING.
2. Select TIME DISPLY.
3. Select ON or OFF as desired. In this example,
OFF has been selected and so the LCD no
longer shows the time.
1. Select GPS/DATA, then SETTING.
2. Select LL DISPLAY.
3. Select ON or OFF as desired. In this example,
OFF has been selected and the screen no
longer shows the vessel position.
1. Select GPS/DATA, then SETTING.
2. Select COG/SOG.
3. Select ON or OFF as desired. In this example,
ON has been selected, so the screen shows the
bearing and speed.
19