Congratulations on your purchase of the Shoprider scooter. This scooter incorporates the ® latest innovative designs patented and only available on a Shoprider scooter. This scooter can be used in confined spaces both indoors and outdoors. Direct drive transaxles and ®...
SAFETY ADVICE • Do not carry passengers. • This mobility Product is intended to assist you. For your own safety, please read the Owner’s Manual before using the Scooter. If in any doubt, contact your supplier directly for advice. • Do not exceed inclines over 9 degrees (15% grade). •...
Page 5
failure of the device, the scooter and personal injury. • Make sure the tiller is properly adjusted and locked to the user or damage and injury could result. • It is not allowed to have any person sitting in the scooter when transported by a vehicle, otherwise any injury or damage that might result.
EMI Warning ® Shoprider scooters may be susceptible to electromagnetic interference (EMI), which is a kind of interfering electromagnetic energy (EM) emitted from sources such as radio stations, TV stations, amateur radio (HAM) transmitters, two-way radio, and cellular phones. The interference (from radio wave sources) can cause the scooter to release its brakes, move by itself, or move in unintended directions.
Page 7
EMI. NOTE! There is no easy way to evaluate the overall immunity of the scooter. ® 5. Report all incidents of unintended movement or braking to your Shoprider dealer, and note whether there are sources of EMI nearby.
Tiller Angle Adjustment (Fig. 1) The red lever located on the left hand side at the joint base of the tiller is used for tiller angle adjustment. Push the lever to release the pin and select the required tiller angle. Refit Tiller Angle the pin into one of the five location holes to Adjustable Lever...
Page 9
Seat Slide & Swivel Adjustment (Fig. 4) Pulling up on the seat slide lever allows the seat position to be adjusted forward or backward. Release the lever and the seat will lock in that position. Under the right side of the seat there is a spring loaded red lever.
SCOOTER TILLER CONTROLS (Fig. 7) Fig. 7 (1) Speed Controls The speed control allows you to set a speed between 1 (minimum) and 10 (maximum). Turn the dial knob counter-clockwise to “minimum” to decrease speed, and clockwise towards “maximum” to increase your speed. (2) Battery Level Indicator The gauge is marked from “E”...
Page 11
(5) Thumb/Finger Lever Controls The left thumb/finger lever controls the reverse and the right thumb/finger lever controls the forward motion. The amount of pressure applied to each lever will determine the speed the scooter travels at. Release the lever and the scooter will slowly come to a stop and the electromagnetic brake will be applied.
FREE WHEEL OPERATION (Fig. 8) The free wheel release lever (red handle) is located inside the right / left rear wheel. To disengage the motor, lift up the lever (the scooter can now be pushed). To re-engage the motor push down on the lever. WARNING! Always re-engage the free wheeling device after use.
STARTING TO DRIVE YOUR SCOOTER Getting Started • Select a level area with plenty of space. • Mount the scooter, either by lifting the arm and sliding on to the seat or rotate the seat outwards and then rotate the seat back to face the tiller. •...
EXTRA GUIDELINES IN THE CONTROL OF YOUR SCOOTER Ramps The stability of your scooter is governed by several factors such as the seating position, the angle of the slope and your height and weight. When approaching an incline, do so directly and not at an angle and whenever possible avoid making turns.
Once the batteries are completely charged, unplug the A/C cord from the wall then unplug the 3-pin lead from the scooter tiller. ® WARNING: Only use the original Shoprider approved charger! This charger is for indoor use only. DO NOT expose it to rain or water spray.
MAINTENANCE Lubrication At six-month intervals you should lubricate the following parts with a light oil or similar lubricant: • Seat pivot post. • Seat release lever pinion. • Wheel bearings. • Axle of scooter. CAUTION – DO NOT USE WD40 TO LUBRICATE PARTS!! DO NOT LUBRICATE TRANSAXLE/GEAR BOX!! In the event of any difficulties please consult your dealer.
Please consult your dealer if your scooter does not run after checking these points. Please consult your selling Shoprider provider if your scooter does not run after checking these points.
TECHNICAL SPECIFICATIONS Model Name TE-889NR TE-889NRS 1350(53) x 600(24) x 1400(55) x 600(24) x Overall Dimensions: L x W x H mm(in) 1130(44.5) 1340(63) Front Pneumatic Tire Diameter pcs x in 2 x 12.5 Rear Pneumatic Tire Diameter pcs x in 2 x 12.5...
This scooter is not intended to be used by individuals with physical limitations that could prevent ® the user from operating the scooter safely. SHOPRIDER disclaims all responsibility for any personal injury or property damage, which may occur as a result of improper or unsafe use of its products.
Need help?
Do you have a question about the TE-889NRS and is the answer not in the manual?
Questions and answers