Amerec E200 Operating Instructions

ROOM TEMPERATURE SETTING
Degrees Fahrenheit
P.M. LIGHT
Glows During P.M. Hours
AMEREC
OPERATING INSTRUCTIONS FOR
PRODUCTS
RESIDENTIAL SAUNA CONTROL
SAUNA CONTROL
(MODEL: E200)
SECTION 1: OVERVIEW
1. TIME CLOCK
The control includes a 24 hour time clock with
the time of day displayed when there is power
to the control. The "PM" light on the face of the
control lights up during afternoon and evening
hour settings. Upon initially turning on the
circuit breaker, or if power is interrupted, the
hour of day will begin flashing, indicating you
are ready to set the time of day.
2. TEMPERATURE & LENGTH
OF HEATING TIME
The control allows you to set the room
temperature with a maximum setting of 200
degrees fahrenheit. Depending on personal
preference, normal temperature setting should
be at or near 175 degrees, which is the
1)
pre-programmed setting.
The length of heating time may also vary with
personal preference. Thirty minutes is the
pre-programmed setting for the length of
heating time and the maximum duration is 60
minutes. When the unit is turned on the set
room temperature and remaining length of
heating time will be displayed on the face of the
control as it counts down to zero and shuts off.
3. 7 DAY PROGRAMMING (Control Dip
Switches must be re-set for operation).
The seven day time clock allows the operator to
program one time each day in a repetitive 7 day
cycle for the unit to come on at a desired
temperature and for a specified length of
heating time. The control is shipped with the 7
day programming turned OFF. To make this
feature operational, the control dip switch must
be re-set (see section 3). Once programmed,
the unit will automatically come on at the hour
of the day and for the length of heating time you
set for each day and will continue to repeat the
same program each following week. If you wish
to stop the unit from automatically coming on,
just set the length of heating time to "00' for
days 1 through
7.
If you plan to leave the unit unattended for an
extended length of time, you should set each
days' length of heating time to zero, so that the
unit will not operate during your absence.
SECTION 2: OPERATION OF YOUR AMEREC SAUNA HEATER
1. Be sure that the circuit breaker to the heater The control is pre-set to heat the room to 175
is ON. degrees for a 30 minute duration.
6. Enter the sauna room and close the door to
prevent heat from escaping.
2. On the initial start-up, set the clock
according to the instructions in Section 3.
3. To activate the heater, push the ON button.
4. If you wish to change the pre-set
temperature or duration, see instructions in
Section 3.
5. Wait for the room temperature to reach the
desired setting.
7. Relax and enjoy the soothing heat, relaxing
tense muscles and refreshing the entire body.
SECTION 3:•PROGRAMMING YOUR SAUNA HEATER CONTROL
CLOCK
(Hour : Minutes)
LENGTH OF HEATING TIME
Duration in Minutes
continueddir
4211-17 7/91