Advertisement
Quick Links
Skywalker X-5 Fly wing for FPV
Welcome to buy X-5 fly wing, this is a small sized FPV aircraft, but it has enough lift area to carry
DC or gopro. It is suitable for cruising at a speed of 60KM/H. It also has a relatively spacious
cabin and is convenient to carry around. The installation is very simple. Look at its accessories
and installation instructions below .
Advertisement
Related Manuals for Skywalker X-5
Summary of Contents for Skywalker X-5
- Page 1 Skywalker X-5 Fly wing for FPV Welcome to buy X-5 fly wing, this is a small sized FPV aircraft, but it has enough lift area to carry DC or gopro. It is suitable for cruising at a speed of 60KM/H. It also has a relatively spacious cabin and is convenient to carry around.
- Page 2 Parts in the accessories bag: 1 glue , 2 steel tie rods, 2 extension cords , 2 rudder horns and quick connector. And 4 fixed screws for motor and 2 for hatch cover. First disconnect the winglets...
- Page 3 Spread the glue evenly over the winglets and fuselage and wait for five minutes, then adhere the winglets to the fuselage. Installation of motor: here for 2212 ~ 2215 KV 1600~1900 outer rotor brushless motor, generally it is high speed flight, so we need to adjust the thrust line with two gaskets.
- Page 4 Spread the glue evenly between the motor base and the layer, wait until it is non-sticky, they can be pressed, as for binding benchmark, the bottom edge shall prevail.
- Page 5 The angle is like this after binding Glue the servo and rudder horn, power on the receiver and make servo stop in the mid-position, and then lock the regulator. After that cut the aileron. Here are advices for players who are new to this fly wing : aileron deflection angle ,which is -20/+20 degrees, is more appropriate.
- Page 6 Cut some CCD briquette in front of hatch...
- Page 7 Gluing on the fuselage Gluing the antenna base of the data radio...
- Page 9 Try whether CCD is suitable for installation...
- Page 10 Basically completed...
- Page 11 It is looks like this after attaching stickers...
- Page 12 When you use a wide-angle lens, you need to cut the front part into some bevels, so as not to keep out line of sight.
- Page 13 Data radio or other devices can be installed above the engine cover, install battery in the forecabin, which is suitable for 2200ma4S batteries. Midbin is fit for placing DC or goupro toward the ground, the rear cabin for OSD and etc. Please use a cable to extend the video transmitter antenna to the far-end of the wing, which can avoid the interference of GPS module's placement on the front inner side of the engine cover.
Need help?
Do you have a question about the X-5 and is the answer not in the manual?
Questions and answers