For Your Safety Read Before Lighting; Lighting Instructions; Operating Instructions - Malm Fireplaces Zircon 34 Assembly And Installation Instructions Manual

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
A. Follow these instructions exactly. This appliance has a pilot which must be lighted by hand.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electric switch; do not use any phone in your building.
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's
instructions. If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not
push in or turn by hand, don't try to repair it, call a qualified service technician. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service
technician to inspect the appliance and to replace any part of the control system and any gas
control which has been under water.
1. STOP! Read the safety information above on this label.
2. Push in the control knob slightly and turn clockwise
NOTE: Knob cannot be turned from "PILOT" to "OFF" unless knob is pushed in slightly. Do not
force.
3. Wait five (5) minutes to clear out any gas. If you smell gas, STOP! Follow "B" in the safety
information above on this label. If you do not smell gas, go to the next step.
4. Turn knob on gas control counterclockwise
5. Push in control knob all the way and hold in. Immediately light the pilot by pushing in the red
lighter button. Continue to push the red lighter button until the pilot is lit. Continue to hold the
knob in for about one (1) minute after the pilot is lit. Release the knob and it will pop back up.
If the knob does not pop up, turn off the gas shut off valve and call a service technician. Pilot
should remain lit. If it goes out, repeat steps 3 through 6.
6. Turn gas control knob counterclockwise
To Turn Off
1. Push in gas control knob slightly and turn clockwise

OPERATING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING

LIGHTING INSTRUCTIONS

Control Valve
to "PILOT."
to "ON."
Page -7
to "OFF".
Pilot Assembly
to "OFF." Do not force.