Location And Function Of Controls - Sony SRX-R320 Operating Instructions Manual

Location and Function of
Controls
Front/Sides
4
a 8-inch duct attachment part
Install an 8-inch duct for exhaust.
b Ventilation holes (intake)/air filter (right side)
Contact Qualified Sony Service Personnel for replacement
of an air filter.
c Lens attachment part
Contact Qualified Sony Service Personnel for attachment
of an optional lens.
d Ventilation holes (exhaust) (left side)
Rear
1
2
3
4
RS-232C
5
INGEST PORT
a STATUS MESSAGE window
Displays various messages.
For details on the messages, see page 18.
b Status indicators
Combinations of the MAIN and LAMP indicators indicate
the status of the projector as follows:
MAIN
indicator
z (in red)
1
z
(in green)
2
(in green)
z
3
(in green)
z: Lights
c Power switch
Turns on/off the main power.
To turn off the projector completely
The projector is ready to be turned off when the LAMP
indicator flashes in green then lights in red steadily. You
can then turn off the power switch to turn off the projector
completely.
d RS-232C connector
Connects the SRX controller. This is for service use.
e INGEST PORT connector
Connects a removable drive to ingest the digital cinema
contents.
Note
If you use this connector, you must make the necessary
connections with this connector inside the projector
housing. For details, contact Qualified Sony Service
Personnel.
LAMP Status of the projector
indicator
z (in red) The unit is in standby mode. You can
turn on the unit with the controller.
z The unit is turned on with the
(in green) controller. You can operate the unit
with the controller.
The unit is in standby after shutting it
down with the controller. Cooling fans
(in green)
are running.
The unit is in lamp-off mode.
(in green)
: Flashes

Location and Function of Controls

17