Boil Out; Polishing - Frymaster 3000 Operation Manual

Hide thumbs Also See for 3000:
Table of Contents

Advertisement

1.9.6 Boil Out

(NOTE: To enter boil out mode, the controller must be OFF)
Never leave the fryer unattended during the boil-out process. If the boil-out solution boils over, turn
the fryer off immediately and let the solution cool for a few minutes before resuming the process.
Do not drain boil-out solution into a shortening disposal unit (SDU), a built-in filtration unit, or a
portable filter unit. These units are not intended for this purpose, and will be damaged by the solution.
Left Display
Follow steps to Entering Filter Menu Mode on page 1-12. The controller must be off.
BOIL OUT
Boil Out Now?
IS VAT PREPARED?
REMOVE Filter Pan
IS SOLUTION IN THE VAT?
START BOIL OUT
BOIL OUT
Boil Out Done
IS SOLUTION REMOVED?
OFF
Remove all drops of water from the frypot before filling with oil. Failure to do so will cause spattering
of hot liquid when the oil is heated to cooking temperature.

1.10 Polishing

The 3000 displays a series of prompts when a polish filter cycle is under way. To initiate a polish, press and hold the
arrows simultaneously. The steps are detailed below. A "waiting to polish" message may display until the signal is received
that the vat is ready for polish cycle to begin.
Left Display
Polish Now?
Filter PAN READY?
OPEN DRAIN VALVE
Draining
Turn Filter On
POLISHING
Close drain valve
FILLING
TURN FILTER OFF WHEN FULL
Off
Right Display
Blank
Yes No
Confirm
Confirm
CONFIRM
Confirm
30:00
CONFIRM
CONFIRM
OFF
Right Display
Yes NO
Confirm
Blank
:40 sec. countdown timer
Confirm
15-MINUTE COUNTDOWN TIMER
Blank
:45 sec. countdown timer
CONFIRM
off
DANGER
WARNING
Press .
Press
to continue.
Ensure vat is empty and drain closed and press
Remove the filter pan and press
Ensure solution is in the vat and press
Press
. Turns on and heats to 195ºF (91 ºC).
The boil-out timer starts.
The countdown timer begins.
Press
to confirm and cancel the alarm.
Once solution is removed press
DANGER
Explanation/Action
Respond to prompt with button push. Press
under NO. Yes starts a polish, detailed below. No delays
filter for 30 minutes and cooking continues. Answering NO
after two prompts cancels polish.
Press
when replaced.
Open the drain valve.
None required.
Turn filter on and press
None required. The oil flows from the filter pan to the frypot
and back to the filter pan for 15 minutes.
Close the drain valve.
None required.
Turn filter off and press
1-15
Action
.
.
to confirm.
under YES or
.
.
.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 3000 and is the answer not in the manual?

Questions and answers

Table of Contents