Remote Control - Nokia Mediamaster 150T User Manual

REMOTE CONTROL

This section describes how to operate the Mediamaster using the buttons on the remote control.
Some of the functions can also be performed by using the buttons on the front panel.
Press once to turn the sound off/on (mute).
Press and hold for a few seconds to switch the Mediamaster in and out
of standby mode.
0 - 9
Change channels and enter values in menus. Note: If 0 is entered as the
first digit in viewing mode, the TV Release functionality is activated (see
below).
0
TV Release. To switch between digital TV/Radio, analogue TV, satellite TV
and VCR.
info
To display short and extended information (if transmitted) about current
and next programmes. Brings up the viewing banner in viewing mode.
back
Go back one level at a time within menus without storing any settings.
To toggle between the present and previous TV/Radio channels in view-
ing mode.
Close the Navi Bars.
select
Confirm choices and selection of a highlighted item.
Open the Navi Bars.
opt
Select service options in viewing mode.
txt
Press to enter teletext (if available).
Move up in the menus and
change to the next channel in
viewing mode.
Cursor left
Move left/change set-
tings in menus.
Decrease the volume
level in viewing mode.
Move down in the menus
and change to the previous
channel in viewing mode.
The cursor button
Cursor up
Cursor down
Cursor right
Move right/change settings in
menus.
Increase the volume level in
viewing mode.
GB 9