Samsung WAM7500 User Manual page 17

4 Wait until the LED indicator on the Product stops flashing. If the Product's LED indicator
turns solid blue, pairing is complete. The Product may also beep.
NOTES
Place each Product at least 20 inches (50 cm) from the HUB when connecting them to the HUB.
Your smart device cannot connect to the Product or the HUB if there is no wireless router.
To confirm you have a proper connection, check the pairing indicator on the front of the HUB.
- When you turn on the HUB for the first time, there is a 20 minute pairing period.
The pairing indicator (
the SPK ADD
pairing indicator (
to pair while the pairing indicator is flashing.
- If pairing mode is turned off, start pairing mode again by pressing the
side of the hub and restart the product, or press and hold both
at the same time for more than 5 seconds.
For a proper connection, connect the HUB to your router before turning on the Product.
- Connecting the Product to the HUB may take a few minutes.
- There will be a brief sound when the connection is established.
5 Connect your smart device to your Wi-Fi network. (The HUB and the smart device should
be connected to the same router.)
) will blink for these 20 minutes or until pairing occurs. When you press
button to pair additional Products, the pairing period is reduced to 10 minutes. The
) flashes for 10 minutes or until pairing occurs. Turn on the Product you want
17
SPK ADD button on the rear
Source and Standby buttons