Firebrick Installation Instructions; Wood Stove - Pacific energy SUMMIT Installation And Operating Instructions Manual

This package contains 17 full-size firebricks, as well as 7 various cut-size bricks.
If your heater came with an ash cleanout system, or an optional one is being installed, one brick (D) will not be needed for
your installation.
With the woodstove in the upright position, install firebricks as follows:
1) Place the firebricks on the bottom of the unit first. Use a total of 6 full-size (D) and 5 cut bricks (A, B, C & 2E) with ash
cleanout system or 7 full-size (D) and 3 cut bricks (C & 2E) if the ash cleanout system is not used.
2) Next install the side firebricks, 2 full-size and 2 cut firebricks(F) on each side of the firebox as shown.
3) Finally install 4 full-size bricks against the rear wall as shown.
F
D
A
B
With Ash Cleanout System Installed
ITEM SIZE
A 1 1/2" X 4 1/2" X 1 1/4"
B 4" X 4 1/2" X 1 1/4"
C 7 1/4" X 4 1/2" X 1 1/4"
D 9" X 4 1/2" X 1 1/4"
E 9" X 4 1/2" (cut) X 1 1/4"
F 9" X 3 1/2" X 1 1/4"
18

Firebrick Installation Instructions

Pacific Summit and Summit Classic
E
C
F
(39 mm x 115 mm x 32 mm)
(102 mm x 115 mm x 32 mm)
(184 mm x 115 mm x 32 mm)
(230 mm x 115 mm x 32 mm)
(230 mm x 115 mm (cut) x 32 mm)
(102 mm x 115 mm x 32 mm)

Wood Stove

D
D
Without Ash Cleanout System Installed
F
E
C
PART NUMBER
248.001
246.001
245.001
5096.99
3245.011
3245.501
SUMMIT-B 280416-24