Nokia N81 User Manual page 122

Phone IP address (for IPv4 only)—Enter the IP address of
your device.
DNS address—In Primary DNS
address of the primary DNS server. In
address, enter the IP address of the secondary DNS server.
Contact your internet service provider to obtain these
addresses.
Proxy server address—Define the address for the proxy
server.
Proxy port number—Enter the proxy port number.
Wireless LAN access points
Follow the instructions from the wireless LAN service
provider.
WLAN network name—Select
for networks. If you select an existing network,
network mode and
by the settings of its access point device.
Network status—Defines whether the target network is
hidden or not.
WLAN network mode—Select
network and to allow devices to send and receive data
directly; a wireless LAN access point device is not needed.
In an ad-hoc network, all devices must use the same
WLAN network name.
122
address, enter the IP
Secondary DNS
Enter manually
WLAN security mode are determined
Ad-hoc to create an ad hoc
WLAN security
802.1x (not for ad hoc networks), or WPA/WPA2. If you
select Open network, no encryption is used. The WEP,
802.1x, and WPA functions can be used only if the network
supports them.
WLAN security
selected security mode:
Security settings for WEP:
•
Wep key in
create up to four WEP keys. The same settings must be
entered on the wireless LAN access point device.
• Authentication
authentication type between your device and the
wireless LAN access point device.
•
WEP key
or Search
the key), WEP key format (ASCII
WLAN
WEP key
Security settings for
•
WPA/WPA2—Select the means of authentication:
to use an extensible authentication protocol (EAP)
plug-in, or
Complete the appropriate settings:
• EAP plug-in settings
as your service provider instructs.
mode—Select the encryption used: WEP,
settings—Enter the settings for the
use—Select the WEP key number. You can
type—Select Open or
settings—Enter WEP encryption
or Hexadecimal), and
(the WEP key data in the selected format).
802.1x and WPA/WPA2:
Pre-shared key to use a password.
(only for EAP)—Enter the settings
Shared for the
(length of
EAP