A Fault Message Appears In The Display - Miele PW 6065 Vario Operating And Installation Instructions

A fault message appears in the display

Message in the display
p
Water intake fault
Open the stopcock
and
check the inlet hose.
,
Technical fault
,
Fault
Disinfection
temperature
not reached
q
Drain fault
Clean the drainage
system.
o
Waterproof system
fault
Fill the container
or
O
Fault
Container empty
A To switch off the fault message, press the multi function selector.
Possible cause
The water inlet is
blocked or restricted.
The water pressure is
too low.
There is a fault.
During the
disinfection pro-
gramme the water
temperature was not
reached.
The water outlet is
blocked or restricted.
The water protection
system has reacted.
One of the external
detergent containers
is empty.
Problem solving guide
Remedy A
Check whether
– the stopcock is opened
enough.
– the inlet hose is kinked.
Select Low water pressure in
the Settings/Supervisor level
menu.
Start the programme again.
If the fault message appears
again, contact the Service
Department.
The machine has not carried
out the disinfection cycle
correctly.
Start the programme again.
LP version: Clean the
drainage system.
AV version: Call the Service
Department.
Close the stopcock.
Call the Service Department.
See "Detergent - Empty
sensor".
41