Troubleshooting Guide; Phone Calls - Panasonic RP-BTD10 Operating Instructions Manual

Troubleshooting guide

Before requesting service, make the following checks. If you are in doubt about
some of the check points, or if the remedies indicated do not solve the problem,
consult your dealer for instructions.
General
The unit does not respond
• Press RESET hole while connecting the USB charging cord to the charging
terminal (DC IN). (→ P. 5)
Power supply and charging
Cannot charge the unit
• Make sure the computer is turned on and is not on standby or sleep mode.
• Is the USB port you are currently using working properly? If your computer has
other USB ports, unplug the connector from its current port and plug it into one of
the other ports.
• If the measures mentioned above are not applicable, unplug the USB charging
cord and plug it in again.
• Is the LED blinking in red ? There is a charging malfunction if the LED is blinking.
• If the LED is blinking fast in red even when the unit is being recharged in a room
temperature within 10 °C and 35 °C, the battery may have run down. (Number of
recharging times of the included battery: Approximately 500.)
LED does not light during charging / Charging takes longer
• Is the USB charging cord (supplied) connected firmly to the USB terminal of the
computer? (→ P. 3)
The power does not turn on
• Is the unit being charged? The power cannot be turned ON during charging.
(→ P. 3)
• Is the detachable cord connected? The power cannot be turned on when the
detachable cord is connected to the unit.
8
8
Bluetooth device connection
®
The device cannot be connected
• Delete the pairing information for this unit from the Bluetooth
them again. (→ P. 3)
Sound and audio volume
No sound
• Make sure that the unit and the Bluetooth
• Check if music is playing on the Bluetooth
• Make sure that the unit is turned on and the volume is not set too low.
• Pair and connect the Bluetooth device and the unit again. (→ P. 3)
®
Low volume
• Increase the volume of the unit. (→ P. 4)
• Increase the volume on the Bluetooth
Sound from the device is cut off / Sound quality is bad
• Sound may be disrupted if signals are blocked. Do not fully cover this unit with
the palm of your hand, etc.
• The device may be out of the 10 m communication range. Move the device
closer to this unit.
• Remove any obstacle between this unit and the device.
• Switch off any wireless LAN device when not in use.
• A communication problem may arise if the battery is not fully charged. Charge
the unit. (→ P. 3)

Phone Calls

You cannot hear the other person
• Make sure that the unit and the Bluetooth
• Check if the unit and the Bluetooth
• Check the audio settings of the Bluetooth
device to the unit if it is set to the Bluetooth
• If the volume of the other person's voice is too low, increase the volume of both
the unit and the Bluetooth enabled phone.
®
® device, then pair
device are connected correctly. (→ P. 3)
®
® device.
® device.
enabled phone are turned on.
®
enabled phone are connected. (→ P. 3)
®
® enabled phone. Switch the calling
® enabled phone. (→ P. 3)