Craig CR45329B Owner's Manual page 7

4. Repeat the same procedures until the desired radio station was found.
5. Adjust the volume to the desired level by pressing VOLUME
6. When finished listening, press and hold the
Antennas:
AM - This unit has a build in ferrite rod antenna, which provides adequate reception in most areas. If
reception is weak, turn the unit to improve reception.
FM - The FM Antenna wire is for FM reception. If reception is weak, unwound and extended the wire or
relocation the wire to improve the radio reception.
Radio stations presetting :
1. Recevie the desired radio station as the previously procedure.
2. Press and hold the O/PRESET/TIME Button until "P XX" appear on the display.
("XX" is program number you stored in).
3. Press the TUNING
number you wanted store in. Press the O/PRESET/TIME Button to save the setting and exit.
4. Repeat the same procedures until all the desired radio stations were stored into the program list.
5. After setting, press the O/PRESET/TIME Button repeatedly to select and plays the desired program.
Notes:
Total 10 of radio stations in AM band and 10 in FM band can be stored into the program list.
If the backup batteries had not installed. When the power supply is failure, the preset program may eased. In
this case, restored the raidio stations as above procedures.
The stored radio station only can be deleted by restore another new radio station.
Alarm setting
Alarm 1 setting:
1. Make sure the unit is in radio power off mode before setting.
2. Press and hold the VOLUME
3. Press the TUNING
(Make sure the PM Indicator is light if the alarm time is PM and not light if the alarm time is AM).
4. When finished settings, press the VOLUME
5. Press the VOLUME
The correspondence indicator will light.
Alarm 2 setting:
Same as Alarm 1 setting but press the VOLUME
Note:
If radio wake up mode was selected, received the desired radio station as previous procedure and set
correct volume level before activate alarm. Otherwise, when Alarm goes off, no sound will heard from the speaker.
Shut off alarm:
1. When alarm goes off, press the
next day.
2. To turn off the alarm completely (not reset for next day). Press the VOLUME
VOLUME /AL.1 (For Alarm 1) Button repeatedly until correspondence indicators turned off.
Snooze:
The alarm can be temporarily turned off manually by pressing the SNOOZE/SLEEP Button;
the alarm will turn back on automatically nine (9) minutes later. This feature can be repeated until the
FM Button was pressed.
OPERATION
/ MINUTE or TUNING
/AL.1 Button until alarm 1 time appear on the display and blinking.
/MINUTE OR TUNING
/AL.1 Button to save the settings and exit.
/AL.1 Button repeatedly to set the wake up mode to Buzzer or Radio as desired.
-- AM/FM Button to turn off alarm, the alarm will reset for
- EN 6 -
/AL.1 or VOLUME
--- AM/FM Button to turn off the radio.
/HOUR Button repeatedly to select the program
/HOUR Buttons to set minute and/or hour.
/AL.2 Button instead of VOLUME
/AL.2 Button
/AL.1 Button.
/AL.2 Button (For Alarm 2) or
--- AM/
.