Dell Inspiron 4000 Service Manual page 33

1. Place the bottom edge of the LCD panel in the bottom of the top cover, and elevate the top of the panel with your hand.
2. Lay the LCD panel in the top cover.
3. Reinstall the five M2 x 4-mm screws securing the LCD panel to the top cover.
Removing the Display-Feed Flex Cable
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the
1. Remove the hard drive assembly.
2. Remove the display assembly.
3. Remove the display assembly
4. Remove the tape that covers the connector to the LCD panel located at the top of the display-feed flex cable.
5. Hold the connector at the top of the display-feed flex cable, and pull down and away to remove it from the LCD panel.
Display Assembly Latch
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the
1. Remove the hard drive assembly.
Computer" before performing the following procedure.
bezel.
Computer" before performing the following procedure.